Trust Computer Products 1290Z Message Solution, No power, Camera won’t, Take a picture, Work

			TRUST 1290Z POWERC@M OPTICAL ZOOM
Messages shown on the LCD display, and solutions
	Message		Solution
	[Card Protected]		Memory card is write-protected, remove the card’s write
			protection.
	[Open the Lens		The lens cover is still closed. Open the lens cover.
	Cover]
	[No Image]		No images on the memory card.
	[Rec Error]		Problems have arisen with saving the image. Switch on
			the camera again.
	[Card Error]		The camera cannot format the memory card. Use a
			card reader, or try another memory card.
	Table 10: messages shown on the LCD display
	Problem	Cause		Possible solution
	The camera has	The camera is switched off.		Press the power button to
	no power.			switch on the camera.
				The batteries are
				discharged. Replace the
				batteries with new ones.
				Refer to the section on
				batteries.
				The batteries are inserted
				incorrectly. Check the
				battery orientation. Refer to
				the section on batteries.
	The camera won’t	Memory card full?		Backup your images and
	take a picture.			delete unwanted images, or
				format the memory card.
		Is the camera connected to		The camera’s buttons are
		a computer?		not operational whilst
				connected to a computer.
				Disconnect the camera to
				take photos.
	The flash doesn’t	Is the flash switched on?		Check whether the flash is
	work.			set to automatic, or to	U K
				always on. Refer to the
				section on the flash.
		The batteries may be weak.		The flash cannot be charged
				if the batteries are almost
				empty. Switch off the
				camera, and wait a few
				seconds before switching it
				on again. If this doesn’t
				solve the problem then
				replace the batteries.
	The images are	The camera or subject was		Hold the camera still;
	blurry.	moving when the shot was		if so required, use a tripod.
		taken.		Use the self-timer.
		Adjustment of the lens focus		Check that the lens is
				focused correctly.
				17