Power Management | Digi 90000583_A specification

Power Management

The Power Controller feature allows the administrators of the Digi CM to use console management to control power functions. Power control consists of three basic functions: on, off, and reboot (power cycle).There are two typical scenarios when using a power controller. The simplest scenario is a non-serial device connected to a power controller (for example, an environmental sensor controller or a tape backup device).

Note: Power controller settings can be automatically detected or configured manually.

Chapter 3 Configuration

27

Image 27

Digi 90000583_A manual Power Management

Contents

Digi TS Family 90000583A Configuring the IP Address Chapter ConfigurationChapter Introduction Special Features Modem Emulation Setting Up RealPortSpecial Features Wireless Special Features Embedded Modem Configuration Management Special Features Power Over the Serial PortsSpecial Features IA Industrial Automation Special Features Snmp Digi Contact Information Other Documents in the Library About This Guide Setup Overview Supported Devices About Configuration Methods Accessing the Configuration from the Web Interface Feature Products Availability Configuration DetailsQuick Find Table DNS Introduction N f i g u r i n g t h e I P a d d r e s s Options for Configuring the IP Address and Mask Configuring the IP Address Using ARP-Ping Configuring the IP Address with Digi Port Authority-Remote Accessing the Digi Device Configuring an IP Address using Dhcp and Rarp Button in the upper right corner is also available N f i g u r a t i o n Network Settings Procedure for Using a Name Server Configuring the Serial Ports Service Base Socket Network Port Configuration Port Profiles TCP Sockets Serial Bridging Printer Industrial Automation Modem Emulation Power Management Custom Feature Description User Configuration Snmp SSH Security Configuration System Configuration Click Outgoing Connections About Autoconnection Configuring a Port for Autoconnection Configuring a User for Autoconnection About RealPort T t i n g U p R e a l P o r t Setting Up RealPort Select Discover Digi Device from the CD Configuration Considerations Click Network Wireless LAN Special Features Wireless Special Features Wireless Embedded Modem E c i a l F e a t u r e s E m b e d d e d M o d e m Special Features Embedded Modem Modem Emulation E c i a l F e a t u r e s M o d e m E m u l a t i o n Serial Device Digi Device Modem Emulation Cable Signals Scenarios for Modem Emulation Originating, Answering, and Disconnecting Calls ATH Modem Emulation AT Command Set Function Result Code Function Result ATP Mand state without disconnecting There is no Nvram support currently AT+MS Ascii Registers Function Range Units Saved Default Register Function Range Units Saved Default Register Function Range Units Saved Default 17 11h =XON/XOFF &K4 Result Codes Short Long Form Special Features Modem Emulation Configuring RI Power Serial Power Feature Configuring DTR Power Serial Power Table OUT Special Features IA Industrial Automation Configuring Industrial Automation with ModbusPage About Snmp and the Device Server Agent E c i a l F e a t u r e s S N M P MIB Configuration Procedure Web Interface Copying the Configuration to and from a Remote Host Click Backup/Restore RestoreUpgrading the Firmware Resetting Configuration to Defaults Color State Indicates Interpreting the LEDs Device EIA 232/422/485 Switch Settings Function Safety Statements Rack Mounting Installation PortServer TS 16 Rack and DC Rack External Wiring Specifications Mechanical PortServer TS PortServer TS 2/4 Mechanical Regulatory Notices Digi One TS, PortServer TS 2/4, PortServer TS 2/4 MEI Certifications Maximum Permissible Exposure Wireless only Digi Contacts Digi Contact Information