| 1 |
| 2 | 3 |
4 | 5 |
| 6 | 7 |
8 |
| 12 |
| 9 |
|
|
|
| |
| 15 | 16 |
| 14 |
10 |
| 13 |
| 11 |
|
|
| ||
17 | 18 |
| 19 | 20 |
21 | 22 |
| 23 | 24 |
25 | 26 |
| 27 | 28 |
29 | 30 |
| 31 | 32 |
33 | 34 | 35 | 36 | 37 |
38 | 39 | 40 | 41 | 42 |
43 | 44 |
| 45 | 46 |
47 |
| 48 |
|
|
Programming the Remote
30
To find out what function a particular button has for a specific device, find the button number on the Function List and then look in the column for the device you are controlling. For example, button number 5 is the Test Tone button for the AVR45, but it is the “Favorite” button for many VCRs and Satellite receivers. Button number 31 is the Preset Tune Down button for the AVR45, the “Reverse Skip” button for CD players and the “Page Down” button for some cable boxes.
Notes on Using the AVR45 Remote With Other Devices.
•Manufacturers may use different code sets for the same product category. For that reason, it is important that you check to see if the code set you have entered operates as many controls as possible. If it appears that only a few functions operate, check to see if another code set will work with more buttons.
•When a button is pressed on the AVR45 remote, the red light under the
Device Control Selector bfor
the product being operated should flash briefly. If the Device Control Selector flashes for some, but not all buttons for a particular product, it does NOT indicate a problem with the remote, but rather that no function is programmed for the button being pushed.
Macro Programming
The Power button may be programmed to send out a sequence of up to eight com- mands when it is pushed. This enables you to turn on a number of products, and to have a program source turn to a favorite channel or any other command.
To program a macro into the Power button, follow these steps:
1. Press any of the Device Control Selectors band the Mute button dat the same time until the red light under the Device Control Selector turns on.
2.Press the Power button cand note that the Device Control Selector will blink once.
3.Enter up to eight macro steps, by pressing the Device Control button and then the function button for each step you wish to enter. To enter the “Power On/Off” command during macro programming, press the Mute button d. DO NOT press the actual Power Button.
4.When the eight steps have been entered, press the Sleep button ` to enter the commands. The red light under the Device Control Selector will blink and then turn off.
Example: To program your TV, Cable Box and the AVR45 to turn on when the Power button is pressed, first
dto enter the Power command for the AVR. Press the TV Device
Control Selector bto select the TV mode, and then press the Mute button dagain, to select TV Power. Finally, press the CBL
Device Control Selector b followed by the Mute button dto select Cable Power. Press the Sleep button `to enter the commands.