Harman-Kardon AVR45 owner manual System Configuration, Speaker Placement

Page 19

System Configuration

16

When all audio, video and system con- nections have been made, there are a few configuration adjustments to be made. A few minutes spent to correctly configure and calibrate the unit will greatly add to your listening experience.

Speaker Selection and Placement The placement of speakers in a multi- channel-home-theater system can have a noticeable impact on the quality of sound reproduced.

No matter which type or brand of speakers is used, the same model or brand of speaker should be used for the front left, center and right speakers. This creates a seamless front soundstage, and elimi- nates the possibility of distracting sonic disturbances that occur when a sound moves across mismatched front channel speakers.

Speaker Placement

Depending on the type of center channel speaker in use and your viewing device, place the center speaker directly above or below your TV or in the center behind a perforated front projection screen.

Once the center channel speaker is installed, position the left and right front speakers so that they are as far away from one another as the center channel speaker is from the preferred

speaker. If possible, adjust all front loudspeakers so that they are aimed at ear height when you are seated in the listening position.

Using these guidelines, you’ll find that it takes some experimentation to find the correct location for the front speakers in your particular installation. Don’t be afraid to move things around until the system sounds correct. Optimize your speakers so that pans across the front of the room sound smooth, and that sounds from all speakers appear to arrive at the listening position at the same time with- out delay from the center speaker as opposed to the left and right speakers.

Surround speakers should be placed on the side walls of the room, at or slightly behind the listening position. The center of the speaker should face into the room. The speakers should be located so that the bottom of the cabinet is at least two feet higher than the listeners’ ears when seated in the desired area.

If side wall mounting is not practical, the speakers may be placed on a rear wall, behind the listening position. Again, they should be located so that the bottom of the cabinet is at least two feet higher than the listeners’ ears. The speakers should be no more than six feet behind the rear of the seating area.

Center Front Speaker

No more than 24"

Left Front

Right Front

Speaker

Speaker

A)Front Channel Speaker Installation with Direct-View TV Sets or Rear-Screen Projectors

 

 

TV or Projection Screen

 

 

Left Front

Center Front

Right Front

 

Speaker

 

Speaker

Speaker

 

 

No more than 6 feet

when rear-mounted speakers are used

Optional Rear Wall Mounting

 

 

 

 

B)The distance between the left and right speakers should be equal to the distance from the seating position to the viewing screen. You may also experiment with placing the left and right speakers slightly forward of the center speaker.

listening position. Ideally, the front channel speakers should be placed so that their tweeters are no more than 24" off center from the tweeter in the center channel speaker.

Depending on the specifics of your room acoustics and the type of speakers in use, you may find that imaging is improved by moving the front left and right speak- ers slightly forward of the center channel

Subwoofers produce non-directional sound, so they may be placed almost anywhere in a room. Subwoofer place- ment is highly influenced by room size and shape, and the type of subwoofer used. Follow the instructions of the sub- woofer’s manufacturer, or experiment with the best location for a subwoofer in your listening room.

At least 6 inches from ceiling

At least 2 feet

Image 19
Contents AVR45 AVR45 Audio/Video Receiver Table of ContentsStaple or clip original invoice here Introduction Description and FeaturesImportant Safety Information Safety InformationMoving the Unit CleaningUnpacking Typographic Conventions÷ õ Front Panel ControlsFront Panel Controls Front Panel Controls R Q P O N M Front Panel Information DisplayFront Panel Information Display C b a á ¡ àß £ ¢ Rear Panel ConnectionsRear Panel Connections Remote Control Functions Remote Control Functions OFF Connect the analog output of a CD player to the CD inputs ¤ Installation and ConnectionsSystem Installation Audio Equipment ConnectionsSpeaker’s manufacturer Remote Control ExtensionExternal Audio Power Amplifier Connections AC Power ConnectionsSpeaker Placement System ConfigurationPlug the Power Cable Þto an unswitched AC outlet System SetupSpeaker Configuration System Configuration Output Level Adjustment To set the delay times, follow these steps Delay SettingsPress the Set button i÷ Source Selection Surround Mode SelectionOperation Basic OperationSurround Mode Chart Dolby Digital Digital Audio PlaybackChannels being decoded as follows PCM Audio Playback Night ModeTape Recording Preset TuningRecalling Preset Stations Tuner OperationProcessor Reset Memory BackupSix-Channel Direct Input Auto Search Method Programming the RemoteProgramming the Remote Direct Code EntryProgrammed Device Functions Code ReadoutMacro Programming Programming the RemotePress the Volume Up button z Press either the AVR aor Volume Punch-ThroughRe-Assigning Device Control Selectors Aux DVD Function ListNo. Button Name CD TapeReference for Function List Manufacturer/Brand Setup Code TablesSetup Code Tables TV Realistic VCR Setup Code Tables VCR Setup Code Tables AUX DVD Cable Troubleshooting Guide Troubleshooting GuideTechnical Specifications