Getting started
Installing and charging the battery pack
To charge the batteries:
1.Ensure that the power to the electrical outlet is turned on and that Rovio is turned on by pressing the power button; Rovio’s LEDs will light up.
2.Place Rovio in its assembled charging dock as illustrated.
The LEDs on Rovio will pulse quickly to indicate that it has begun charging.
3.During charging, the LEDs on Rovio will pulse slowly; a single charge takes approximately two
hours.
When Rovio has finished charging the LEDs will remain lit. It is safe to leave Rovio on its charging dock after the charge has completed.
Low battery
When Rovio’s batteries begin to run low, it will warn you with the following:
•Rovio interface warning message.
•Power switch LED light indicator flashes green, orange or red (refer to the section Power switch LED light indicator).
If Rovio is in the same room as its charging dock and the interface indicates that it has a navigation signal, it will automatically try to return to the charging dock when its batteries are running low after you click on the low battery warning message.
Otherwise, you can send it back to its charging dock by clicking on the Home 
button on the interface. Refer to the Auxiliary controls table in the Description of interface section for details.
If you ignore the request to drive Rovio back to its charging dock and continue to use it, Rovio will shut off automatically when its batteries are drained, and you might not be able to drive it back to the charging dock to recharge.
NOTE: Rovio must detect the charging base before it can navigate home.
14