AGFA DC-830 user manual Appendix, Troubleshooting, Problem Cause, Solution

Appendix

Troubleshooting

Problem	Cause
Power does not turn on.	Battery is inserted in the wrong
	direction.
	Batteries are dead.
	The battery compartment door
	is open.
The camera does not take	The flash is charging.
pictures.
	Memory is full.
	Memory card is not formatted
	correctly.
Image is not recorded when	The Flash is charge.
the shutter button is pressed.
	Memory is full.
The flash does not fire	Flash is set to OFF.
Image is blurry or out of focus.	The camera was moving when
	the image was captured.
	The subject was beyond the
	range within which the camera
	can focus.
Image is not displayed on the	A memory card with non-DCIF
LCD monitor.	images (recorded with other
	camera) is loaded.
Recorded images are not	The camera was turned
saved in memory.	off/powered down before the
	image was stored in memory
Cannot transfer images to a	USB driver is not installed.
computer after connecting
the USB cable.
	- 49 -

Solution

Reload battery in the correct direction.

Replace or recharge batteries. Make sure the battery compartment door is securely closed.

Wait for the flash to charge. Insert a new memory card.

The card may be detective, use a new card.

Wait for the flash to charge. Insert a new memory card.

Set the flash to any mode except off. Hold the camera steady when shooting picture.

Turn the Macro mode on it the subject is within 5 cm (zoom out) or 25 cm (zoom in).

Do not use Macro mode when shooting distant subjects.

This camera cannot display non-DCIF images.

If the battery low indicator appears on the LCD monitor, replace the battery immediately.

Install the USB driver before you connect the camera to a computer / turn the camera on.