AGFA DC-630i manual Troubleshooting, Problem Cause Solution

Troubleshooting

Problem	Cause	Solution
Power does not turn on.	Battery is inserted in the wrong	Reload battery in the correct
	direction.	direction.
	Batteries are dead.	Replace or recharge batteries.
	The battery compartment door is	Make sure the battery
	open.	compartment door is securely
		closed.
The camera does not take	The flash is charging.	Wait for the flash to charge.
pictures.
	Memory is full.	Insert a new memory card.
	Memory card is not formatted	The card may be defective, use a
	correctly.	new card.
Image is not recorded when the	The Flash is charge.	Wait for the flash to charge.
shutter button is pressed.
	Memory is full.	Insert a new memory card.
The flash does not fire.	Flash is set to OFF.	Set the flash to any mode except
		off.
Image is blurry or out of focus.	The camera was moving when	Hold the camera steady when
	the image was captured.	shooting picture.
	The subject was beyond the	Turn the Macro mode on it the
	range within which the camera	subject is within 15 cm or 40 cm.
	can focus.	Do not use Macro mode when
		shooting distant subjects.
Image is not displayed on the	A memory card with non-DCIF	This camera cannot display
LCD monitor.	images (recorded with other	non-DCIF images.
	camera) is loaded.
Recorded images are not saved	The camera was turned off /	If the battery low indicator
in memory.	powered down before the image	appears on the LCD monitor,
	was stored in memory.	replace the battery immediately.
Cannot transfer images to a	USB driver is not installed.	Install the USB driver before you
computer after connecting the		connect the camera to a
USB cable.		computer / turn the camera on.
Card error	The memory card format may	Re-format the memory card to
	not be correct.	the FAT format using a card
		reader in Windows.

54