Digimerge DGRT400 user manual Setting up Callback parameters

Page 24

USING THE CLIENT SOFTWARE

quality settings. The image size increases exponentially with higher quality, and can greatly lengthen transmission.

Enable image window auto resize check box lets you disable the rearrangement of image windows inside of a main window, so you can apply your own position and size of image manually. These settings will be saved.

Always display snapshots in its actual size (window resize) check box lets you disable resize and center position of snapshot windows, so one can apply your position and size of snapshot window manually. These settings will be saved.

Skin selection drop down menu allows different graphic user interface representation.

5.2.2 Setting up Callback parameters

DVS has the ability to automatically call the client PC if motion is detected in the monitored area, or if an alarm is set. This is known as a callback function.

DVS will access the client PC after the detection of motion or triggering signals from the alarm sensors, after which it will start transmitting images. The phone number to be dialed and the required actions after the motion or sensors detection are defined in the Callback Properties dialog shown in Figure 8. You need to type in the Callback phone number (be sure that you have selected correct Tone Dial or Pulse Dial mode), select the folder for saving images in Save callback images to field, specify the number of sequential callback attempts (up to 5), time interval between dialing series, and select a Sound beep, if desired, to receive sound notification on Callback. If you wish to proceed with Callback mode after successful callback attempt, check Auto proceed callback mode after callback event checkbox. Please refer to the section 5.9 on page 41 for further details on the callback function.

24

Digimerge Dialup Video Server User’s Guide

Image 24
Contents Dial Up Video Server Page Table of Contents Warranty PAGE………………………………………..………………….………55 General Information IntroductionGeneral Information Technical specification System requirementsGeneral Information Remote Unit Installation Remote Unit Installation DVS unit rear view Software Installation Uninstallation Using the Client Software Getting started with Digimerge DVS client program Image windows Main control panel Status barMain control panel Getting initial images from the DVS Dialing up a remote unitUsing the Client Software Example image received from a DVS unit Image window description Shows all controls available from the image windowDigimerge Dialup Video Server User’s Guide Configuring the remote DVS unit Modifying basic and image parametersSelecting image path, snapshot quality and other parameters Setting up Callback parameters Configuring the alarm sensors Configuring the alarm sensors Digimerge Dialup Video Server User’s Guide Setting external DVS modem parameters Changing external modem parametersDigimerge Dialup Video Server User’s Guide Motion Detection Control Motion sensitivity control windowRelays and sensors control Filling image memory indicator Internal image memory managementDownloading snapshots Controlling Pan, Tilt, Zoom, Focus of remote cameras Pan, Tilt, Zoom, Focus window for Sony EVI camerasCamera ID selection dialog Audio stream control Line in / MICDigimerge Dialup Video Server User’s Guide