Canon zr10 instruction manual Dubbing, Stop playback on the other device, Copyright signal

4_ZR10_E(73-85) 3/9/00 7:58 PM Page 75 (1,1)

Dubbing

Operate from the controls on the body of the camera or the wireless controller.

Example dubbing to the camera

1.Find a point on your recorded cassette slightly before the section you want to copy and set it to playback pause mode.

2.Press the camera’s REC PAUSE button.

•The camera enters record pause mode.

3.Start playback on the other digital device while you monitor the picture.

4.Press the pause button.

•Recording starts.

5.When you get to the point where you want to stop recording, press the stop button or the pause button.

•Recording stops.

6.Stop playback on the other device.

•If the cable is not connected properly, or if the cable is unconnected when you press REC PAUSE, the camera displays the caution ‘‘CHECK THE DV INPUT.’’ An anomalous image may also flash onto the screen.

•Blanks between recordings on the playback tape are recorded as anomalous images on the tape that is being recorded to.

•During DV dubbing you cannot add digital effects or faders.

E

Copyright signal

Certain pre-recorded software tapes are copyright protected. If you try to play back such a cassette, “COPYRIGHT PROTECTED PLAYBACK IS RESTRICTED” appears in the display for a few seconds and then the camera displays a blank blue screen; you cannot view the contents of the cassette.

If you try to record from such a tape via the digital cable “COPYRIGHT PROTECTED DUBBING RESTRICTED” appears in the display; you cannot record the contents of the tape.

Editing

75