Network Parameters, Device ID, Custom Groups

Shure UHF-R Wireless

Network Parameters

NOTE:

•The receiver reboots after you press ENTER to accept net- work parameter changes

•In dual models (UR4D), these settings affect both receivers (the dual receiver is treated as a single network device).

Menu: Util > Network

1.Push the Control wheel to move the cursor to the Mode parameter.

2.Turn the Control wheel to set the receiver to one of the following values:

•DHCP: use this setting when connecting the receiver to a DHCP server.

•Manual: allows you to set the receiver to a specific IP ad- dress or subnet.

Menu: Util > Network

NOTE: To change these settings, the network mode must be set to Manual.

1.Push the Control wheel to move the cursor to any of the following parameters:

•IP (IP address)

•Sub (Subnet mask)

2. Turn the Control wheel to change the value.

Assists in identifying receivers through the Wireless Work- bench Software (has no effect on network identification).

Menu: Util > Network

1.Push the Control wheel to move the cursor to the DevID parameter.

2.Turn the Control wheel to set the receiver to change the value.

This feature allows you to create your own groups of frequencies.

Menu: Radio > Custom

1.Turn the Control wheel to select a custom group number (U1, U2, U3, etc.)

2.Push the Control wheel to move to the Channel parameter and turn it to select a channel (01, 02, 03, etc.)

3.Push the Control wheel to move to the Freq parameter and select a frequency for that channel.

4.Push the NEXT menu key to select a frequency for the next channel in that group.