Grizzly G0513X, G0514X3 owner manual Inventory, Lock Washers 8mm Table, Lock Washers 6mm Fence

Inventory

After all the parts have been removed from the crate, you should have the following items:

Crate Contents (Figure 7 & 8):		Qty
A.	Bandsaw (not shown)	1
B.	Table	1
C.	Miter Gauge	1
D.	Back Square Tube	1
E.	Resaw Fence	1
F.	Front Rail	1
G.	Fence Assembly	1
Hardware and Tools:		Qty
•	Eye Bolt M10-1.5 (may be installed)	1

•Flat Washers 8mm

	(Table, Pos. Stop, Fence)	7
• Lock Washers 8mm (Table)		4
• Hex Bolts M8-1.25 x 16 (Table)		4
• Hex Bolt M8-1.25 x 90 (Pos. Stop)		1
• Hex Nuts M8-1.25 (Pos. Stop, Fence)		2
•	Table Pin	1
•	Table Insert	1
• Cap Screws M6-1 x 16 (Fence)		2
• Hex Bolts M6-1 x 20 (Fence)		2
• Fence Handle M8-1.25 x 22 (Fence)		1
• Lock Washers 6mm (Fence)		2
• Flat Washers 6mm (Fence)		2
• Rail Pad M6 x 18 (Fence)		1
• Hex Nut M6-1 (Fence)		1
• Lock Handle M8-1.25 x 44 (Fence)		1
•	Moving Plate (Fence)	1
• Hex Wrench 5mm & 8mm		1 Ea
• Open End Wrench 10 x 13mm		1

BC

Figure 7. Bandsaw components.

E

D

G

F

Figure 8. Fence components.

In the event that any nonproprietary parts are missing (e.g. a nut or a washer), we would be glad to replace them, or for the sake of expedi- ency, replacements can be obtained at your local hardware store.

NOTICE

Some hardware/fasteners on the inventory list may arrive pre-installed on the machine. Check these locations before assuming that any items from the inventory list are miss- ing.

G0513X/G0514X/G0514X3 Extreme Series Bandsaw -17-