Table
The table is heavy and requires two people to lift it onto the trunnions. The saw blade should also be removed to make table installation easier.
Components and Hardware Needed: | Qty |
Table | 1 |
Hex Bolts | 4 |
Lock Washers 8mm | 4 |
Flat Washers 8mm | 4 |
Table Pin | 1 |
Table Insert | 1 |
To install the table: |
|
1.Loosen blade tension by rotating the quick release tension lever clockwise as shown in Figure 14.
Loosen
Tighten
Figure 14. Quick release tension lever.
2.Adjust the upper and lower blade guides away from the blade. Refer to Adjusting Blade Guide Bearings on Page 29 for more details.
All saw blades are dan- gerous and may cause personal injury or death. Wear leather gloves when handling.
3.Open the upper and lower wheel covers, and slide the blade off of both wheels.
Personal injury may occur if the table is lifted without assistance. Get help when installing the table.
4.With the help of another person, lift the table onto the trunnions.
5.Secure the table to the trunnions as shown in Figure 15 with the supplied hex bolts and washers.
Figure 15. Mounting the table.
6.With the blade teeth pointing downward, slide the blade through the table slot.
7.Slide the blade through the upper and lower blade guides, and mount it over the upper and lower wheels.
8.Tighten the quick release tension lever, then install the table insert and table pin.
9.Keep the upper and lower blade guides adjusted away from the blade until the blade tracking and tension have been adjusted.
G0513X/G0514X/G0514X3 Extreme Series Bandsaw |
