Grizzly G0513X, G0514X3 owner manual Replacing V-Belt

Replacing V-Belt

Tools Needed:	QTY
Hex Wrench 6mm	1
Wrench 13mm	1
To replace the V-belt:

1.DISCONNECT BANDSAW FROM POWER!

2.Open both wheel covers, and remove the blade.

3.Loosen the motor mount screws shown in Figure 58.

4.Unthread the wheel mount bolt shown in Figure 59 and slide the lower wheel off of the bearing shaft.

Wheel

Mount Bolt

Figure 59. Wheel mount bolt.

G0513X/G0514X/G0514X3 Extreme Series Bandsaw

5.Rotate the motor to release the tension on the V-belt and pull it off of the motor pulley.

6.Slip the old V-belt off of the wheel pulley and install the new V-belt in its place.

7.Install the lower wheel back onto the bearing shaft and replace/tighten the wheel mount bolt.

8.Rotate the motor to tension the V-belt, then tighten the motor adjustment screw.

9.Check the V-belt tension and adjust if neces- sary as described in the Tensioning V-Beltinstructions.

10.When the V-belt tension is correct, tighten the motor hinge bolt and close the lower wheel cover.

-49-