Grizzly G0513X, G0514X3 owner manual Positive Stop, Hex Bolt M8-1.25 x

5.Loosen the lock lever (Figure 18) so that the blade tracking knob can rotate.

Positive Stop

Blade Tracking

Knob

Lock Lever

Figure 18. Blade tracking controls.

6.Spin the upper wheel with one hand and rotate the tracking control knob with the other hand to make the blade rides in the center of the bandsaw wheel tire.

7.Tighten the tracking control lock knob and close the upper wheel cover.

For the best performance from your saw, regularly maintain proper tracking of the blade.

NOTICE Changes in the blade tension may change the blade tracking.

Personal injury or death can occur if the bandsaw starts during table adjust- ments. Disconnect power from the bandsaw before performing table adjust- ments.

The positive stop allows the table to be quickly and accurately returned to the horizontal (0˚) position after being adjusted to a different angle.

Components and Hardware Needed:	Qty
Hex Bolt M8-1.25 x 90	1
Hex Nut M8-1.25	1
To install the positive stop:

1.Thread the M8-1.25 hex nut halfway onto the M8-1.25 x 90 hex bolt (this is the positive stop bolt).

2.Thread the positive stop bolt into the thread- ed hole on bandsaw body as shown in Figure 19.

Positive Stop

Figure 19. Installed positive stop bolt.

G0513X/G0514X/G0514X3 Extreme Series Bandsaw -23-