Fujitsu S4545, S4546 manual Replacing Mobile Multi-bay Unit, Remove the unit, Install the new unit

❒Replacing Mobile Multi-bay Unit

This section describes how to replace a mobile multi-bay unit.

1Remove the unit.

Raise the mobile multi-bay unit removal lever

(1) and remove the multi-bay unit (2).

2Install the new unit.

Firmly insert it with the connector side facing inward.

SECTION 2

2

1

Mobile multi-bay unit removal lever

IMPORTANT NOTE

￿Always set a mobile multi-bay unit when using the PC. The PC may be damaged if no multi- bay unit is set in place.

￿Raise the mobile multi-bay unit removal lever only when removing the multi-bay unit. Otherwise the lock may be released. Should it be raised accidentally, switch the PC power off, remove the unit, and install it again.

Critical Points

￿To use the built-in Superdisk drive unit, change the BIOS setup settings.

•“Floppy disk A” in the “Main” menu: Not used

•“Floppy disk controller” in “Other built-in device settings” in the “Detail” menu: Not used

47