Canon DM-GL1 instruction manual Returning to a Pre-Marked Position

E

Returning to a Pre-Marked Position

OFF

CAMERA VCR

POWER	REC	SEARCH
	PAUSE	SELECT

ZERO SET	REW	PLAY	FF
MEMORY
AUDIO	– /	STOP	+ /
DUB.
A/V	PAUSE	SLOW	× 2
INSERT

Use the wireless controller to go back to a pre-determined point on a tape following playback.

1. Press the ZERO SET MEMORY button on the wireless controller at a point you want to return to later.

• The time code is replaced by a tape counter that is set to zero with the å indication.

•Press the ZERO SET MEMORY button once more to cancel the zero set memory.

2.When you have finished playback, fast forward or rewind the tape. The tape stops automatically when it reaches the zero set position.

•RTN1 or `RTN appears in the display.

•The tape counter with å indication disappears from the display and the time code reappears.

Notes:

•The zero set memory may not function correctly where there is a break between recordings on the tape.

•You can also use zero set memory to mark a position on a tape in record pause mode. When you then play back the tape, pressing rewind will take you back to the pre-marked position.

•There may be a slight difference between the timecode and the tape counter readings.

•If you remove the tape while the zero set memory is set, the memory is canceled and the tape counter reverts to timecode.

•The camera remembers your setting even if you slide the POWER switch to OFF.

Range of Features

Using the Full

68