Enhancing your system, Troubleshooting chart

Enhancing your system

The connection lead is not included. Purchase a commercially available lead as shown below.

Portable audio

player, etc.

Audio cable (not supplied)

■Listening to the playback sounds of portable audio player, etc.

1Use a connection lead to connect the portable audio player etc. to the AUDIO IN socket.

2Press the ON/STAND-BY button to turn the power on.

3Press the AUDIO IN button on the remote control or FUNCTION button repeatedly on main unit to select AUDIO IN function.

4Play the connected equipment. If volume level of the connected device is too high, sound distortion may occur. Should this happen, lower the volume of the connected device. If volume level is too low, increase the volume of the connected device.

Note:

To prevent noise interference, place the unit away from the television.

Troubleshooting chart

Many potential problems can be resolved by the owner without calling a service technician. If something is wrong with this product, check the following before calling your authorized SHARP dealer or service center.

■ General

Symptom		Possible cause
● When a button is		● Set the unit to the power
pressed, the	unit	stand-by mode and then
does not respond.		turn it back on.
		● If the unit still malfunctions,
		reset it. (Refer page 12)

● No sound	is	● Is the volume level set to
heard.		minimum “L-00”?
		● Are the speaker wires
		disconnected?

■ CD player

Symptom			Possible cause

● Playback	does		● Is the disc loaded upside
not start.			down?
● Playback	stops		● Does the disc satisfy the
in the middle		or	standards?
is not performed			● Is the disc distorted or
properly.			scratched?
● Playback sounds			● Is the unit located near
are skipped,		or	excessive vibrations?
stopped	in	the	● Is the disc very dirty?
middle of a track.			● Has condensation formed
			inside the unit?

■Remote control

Symptom		Possible cause

● The	remote	● Is the AC power lead of the
control	does not	unit plugged in?
operate.		● Is the battery polarity
		correct?
		● Is the battery dead?
		● Is the distance or angle
		incorrect?
		● Does the remote control
		sensor receive strong light?

■ Tuner

Symptom		Possible cause
● The radio	makes	● Is the unit placed near the TV
unusual	noises	or computer?
continuously.		● Is the FM aerial placed
		properly?
		Move the aerial away from
		the AC power lead if it is
		located nearby.

E-11