Madrigal Imaging Audio/Video Preamplifier manual Important Safety Instructions

Page 3

Important Safety Instructions

Please read all instructions and precautions carefully and completely before operating your PAV audio/video pream- plifier.

1.ALWAYS disconnect your entire system from the AC mains before connecting or disconnecting any cables, or when cleaning any component.

2.This product is equipped with a three-conductor AC mains power cord which includes an earth ground connection. To prevent shock hazard, all three connections must ALWAYS be used. If your electrical outlets will not accept this type of plug, an adapter may be purchased. If an adapter is necessary, be sure it is an approved type and is used properly, supplying an earth ground. If you are not sure of the integrity of your home electrical system, contact a licensed electrician for assis- tance.

3.AC extension cords are not recommended for use with this product. If an extension cord must be used, be sure it is an approved type and has sufficient current-carrying capacity to power this product.

4.NEVER use flammable or combustible chemicals for cleaning audio components.

5.NEVER operate this product with any covers removed.

6.NEVER wet the inside of this product with any liquid.

7.NEVER pour or spill liquids directly onto this unit.

8.NEVER block air flow through ventilation slots or heatsinks.

9.NEVER bypass any fuse.

10.NEVER replace any fuse with a value or type other than those specified.

11.NEVER attempt to repair this product. If a problem occurs, contact your Proceed® retailer.

12.NEVER expose this product to extremely high or low temperatures.

13.NEVER operate this product in an explosive atmosphere.

14.ALWAYS keep electrical equipment out of the reach of children.

15.ALWAYS unplug sensitive electronic equipment during lightning storms.

Page 2 Page 4
Image 3
Page 2 Page 4
Contents PR O C E Page Important Safety Instructions Table of Contents More on next Care and Maintenance Maximizing the Value of Your Purchase Unpacking and Placement Operating Voltage Word About Installation Home Theater Proceed PAV Page Front Panel Master Mute Surround Mode Selector Tip Rear Panel Male RCA Male XLR AC Power Switch and AC Power Input Video Outputs Remote Balanced Outputs Please Note PR O C E E D Learning Remote ControlBank Switch Transport Buttons Page Planning Your Installation Correct Size for Your Television Screen Sur Sub Dipolar surround placement Example Wire Lengths AWG Size Feet Stranding System Planning Guide Additional Notes on Speaker Placement System Setup & Calibration Enter the Setup Menu Save Your Changes if ANY by Pressing Enter Input Level Calibration Enter the SET Levels Menu Repeat this Process for Each Speaker in Turn Setting Input Defaults Give the Input a More Specific on Screen Alias You will see a screen which looks like the following You should then see a screen which looks something like this Press Enter to Save Your Change Select the Surround Mode YOU would Like to Modify Enter the Remote Control Menu Page Using the PAV Operate Display Pref Menu Programming the Remote Control D p a SUB ON/OFF Remote only Menu Enter Display On Screen Select stereo surround Planning Your Remote Control Page Room Acoustics Room Modes Your System Settings Page PAV Menu Structure partial PAV Menu Operate SetupTroubleshooting Care and Maintenance Canadian Warranty Obtaining Service 17.25 43.8 cm DimensionsMadrigal Audio Laboratories, Inc SpecificationsInstallation Notes Page PR O C E E DR
Top Page Image Contents