Madrigal Imaging Audio/Video Preamplifier manual

Page 44

default surround mode menu

Programming Video Inputs

video input defaults menu

To change your default surround mode:

1UNDER THE INPUT DEFAULTS MENU FOR THE SELECTED INPUT, SELECT “MODE” AND PRESS EITHER OF THE VOLUME +/– KEYS

You should then see a screen which looks something like this:

DEFAULT SURROUND MODE

NONE

2USE THE VOLUME +/– BUTTONS TO CYCLE THROUGH THE AVAILABLE SURROUND MODES UNTIL YOU SEE THE ONE YOU WOULD LIKE TO HAVE AS A DEFAULT FOR THIS INPUT.

For example, for your CD player you may want to select the stereo sur- round mode, as shown below.

DEFAULT SURROUND MODE

STEREO SURROUND

3 PRESS “ENTER” TO SAVE THIS DEFAULT SURROUND MODE FOR THIS INPUT.

Repeat these programming steps in turn for any inputs which will be used in your system’s configuration.

Video sources have the same input default options outlined above for audio sources, with one addition: you need to tell the PAV whether you are using the composite or the S-video inputs for each of your four video inputs. The very dif- ferent nature of these two signals requires that on screen displays for each be generated differently. (If set incorrectly, the blue field against which the characters are normally displayed will be gray; also, color video will turn black and white for the duration of on screen messages. No real harm is done, but you may won- der why you occasionally lose color.)

All video inputs are set to composite when they leave the factory. We strongly recommend that you standardize on either composite or S-video and use your choice consistently throughout the system. To use the S-video connection on the PAV for a particular video input:

1FROM THE SETUP MENU, SELECT INPUT DEFAULTS, FOLLOWED BY VIDEO INPUTS, FOLLOWED BY THE INPUT YOU WOULD LIKE TO PROGRAM.

Assuming you have already performed the adjustments outline above, your on screen menu might look something like the following (the specifics will vary, of course):

INPUT DEFAULTS

ALIAS LASER

OFFSET -4

MODE THX

VIDEO COMPOSITE

44

Page 43 Page 45
Image 44
Page 43 Page 45
Contents PR O C E Page Important Safety Instructions Table of Contents More on next Care and Maintenance Maximizing the Value of Your Purchase Unpacking and Placement Operating Voltage Word About Installation Home Theater Proceed PAV Page Front Panel Master Mute Surround Mode Selector Tip Rear Panel Male RCA Male XLR AC Power Switch and AC Power Input Video Outputs Remote Balanced Outputs Please Note Learning Remote Control PR O C E E DBank Switch Transport Buttons Page Planning Your Installation Correct Size for Your Television Screen Sur Sub Dipolar surround placement Example Wire Lengths AWG Size Feet Stranding System Planning Guide Additional Notes on Speaker Placement System Setup & Calibration Enter the Setup Menu Save Your Changes if ANY by Pressing Enter Input Level Calibration Enter the SET Levels Menu Repeat this Process for Each Speaker in Turn Setting Input Defaults Give the Input a More Specific on Screen Alias You will see a screen which looks like the following You should then see a screen which looks something like this Press Enter to Save Your Change Select the Surround Mode YOU would Like to Modify Enter the Remote Control Menu Page Using the PAV Operate Display Pref Menu Programming the Remote Control D p a SUB ON/OFF Remote only Menu Enter Display On Screen Select stereo surround Planning Your Remote Control Page Room Acoustics Room Modes Your System Settings Page PAV Menu Operate Setup PAV Menu Structure partialTroubleshooting Care and Maintenance Canadian Warranty Obtaining Service Dimensions 17.25 43.8 cmSpecifications Madrigal Audio Laboratories, IncInstallation Notes Page PR O C E E DR
Top Page Image Contents