Service Note

1.POWER SUPPLY DURING REPAIRS

In this unit, about 10 seconds after power is supplied (8.4V) to the battery terminal using the service power code (J-6082-223-A), the power is shut off so that the unit cannot operate.

These following two methods are available to prevent this. Take note of which to use during repairs.

Method 1.

Use the DC IN terminal. (Use the AC power adaptor.)

Method 2.

Connect the adjustment remote commander RM-95 (J-6082-053-B) to the LANC jack, and set the HOLD switch to the “ADJ” side.

2.TO TAKE OUT A CASSETTE WHEN NOT EJECT (FORCE EJECT)

1Refer to 2-3. to remove the front panel section.

2 Refer to 2-4. to remove the cabinet (L) section.

3 Refer to 2-5. to remove the cabinet (R) section.

4 Open the control switch block (FK-1000).

5 Disconnect CN4401 (2P) of VC-256 board.

6 Add +5V from the DC POWER SUPPLY and unload with a pressing the cassette compertment.

7Pull the timing belt in the direction of arrow A with a pincette while pressing the cassette compartment (take care not to damage) to adjust the bending of a tape.

Pincette

Timing belt

Press the cassette compartment not to rise the cassette compartment

Timing belt

Adjust the bending of a tape

Loading motor

Disconnect CN4401 of

VC-256 board

8Let your hold the cassette compartment and rise the cassette compartment to take out a cassette.

DC power supply

(+5V)

— 4 —