Camera Volume Adjustment

8.Dress extra cable into the hole

(or wall box if used) and position the camera, starting at the top onto the plastic back frame.

9.Fully seat the camera into the back frame and secure the camera with 4mm camera attachment screw (supplied) thru the

bottom of the back frame and camera.

Important: If camera is exposed to outside elements, caulk should be added to the top and sides of the camera at the wall surface. Do not caulk bottom surface.

Operational Checkout

Refer to the instructions provided with NuTone models VSM4SK, or VSUC4SK.

The VSC4S door camera is provided with a volume level adjustment set screw. The adjustment has been pre-set at the factory to provide the optimal volume level at the door camera. The volume level can be adjusted if your specific application requires the level to be either increased or decreased. Insert a jeweler’s screwdriver into the small hole that is shown in the camera illustration. Rotate the small set screw to adjust the volume level.

Important: Do not use excessive force to rotate the screw. Damage could occur to the camera, and loss of audio may result. Use extreme caution when making the adjustment. Do not use a screwdriver that is too big for the application.

VSC4S

Volume Adjustment

Camera Lens Manual Adjustment

The VSC4S door camera is provided with a manual camera lens adjustment. The adjustment can be used to fine tune the angle of the camera lens to compensate for installations that are not directly in line to the viewing area. The adjust- ment is located on the back of the camera, as shown in the camera illustration. Move the adjustment control upward to lower the camera lens. Move the adjustment control down- ward to raise the camera lens. Adjust the camera lens posi- tion to provide the best viewing area for your installation.

VSC4S

Lens Adjustment