Preparation Procedure
Set the camera in the following procedure.
Step 1 Connection and Installation |
|
| ||
Firstly, make a hole on the ceiling and connect the power cable, LAN cable, |
| |||
alarm and others to the terminal of the | ☞ Page 14 | |||
Then, install the camera to a Ceiling Mount Fix a wire securely for preventing | ||||
| ||||
the camera from falling off. |
| |||
|
|
| ||
Step 2 Setting the Network |
|
|
| |
Install the software [V.Networks Controller], and set the network for the PC | ☞ Page 23 | |||
and | ||||
istration of the connected camera with [V.Networks Controller]. |
|
❈In a system where more than one
C655 with V.Networks Setup tool). Only then turn on the power for a second one and go on to same setting. Repeat the procedure for the other cameras. (☞ Page 15)
Step 3 Setting with V.Networks Controller
Use the installed V.Networks Controller to perform the settings for Auto Pan, | ☞ Page 31 |
Auto Patrol, Auto Trace, Picture Quality, Preset Position, Alarm and others.
Step 4 Operations with V.Networks Controller
With V.Networks Controller, Preset Position can be selected as well as start- | ☞ Page 34 |
ing and stopping Auto Pan, Auto Trace and Auto Patrol. |
|
13