Dubbing Still Images Recorded On A Tape To A Memory Card
Still images can be dubbed from a tape to a memory card.
1 Load a cassette. ( pg. 10)
2 Load a memory card. ( pg. 10)
3 Set the VIDEO/MEMORY Switch to “VIDEO”.
4 Set the Power Switch to “PLAY” while pressing down the Lock Button located on the switch.
5 Set “ 
COPY” to “ON”. ( pg. 25, 28)
6 Press 4/9 to start playback.
7 At the point you want to dub, press 4/9 again to engage Still Playback.
8 To dub the image, press SNAPSHOT.
●The “ 
” indication appears during dubbing.
●The selected image is stored in the memory card.
NOTES:
●If SNAPSHOT is pressed in step 8 when a memory card is not loaded, the message “COPYING FAILED” is displayed.
●If an image recorded on the tape using “WIDE MODE”
( pg. 26) is dubbed to a memory card, the WIDE mode identifying signal is not dubbed with it.
●To use Playback Special effects with a video image you wish to dub, perform up to step 8 using the remote control (provided). ( pg. 16)
●Images are dubbed in 640 x 480 pixels.