EDITING EN 37
Audio Dubbing
The audio track can be customized only when recorded in the
●Use the provided remote control.
Insert Editing
You can record a new scene into a previously recorded tape, replacing a section of the original recording with minimal picture distortion at the in and outpoints. The original audio remains unchanged.
●Use the provided remote control.
REW 
INSERT 
STOP
Stereo Microphone |
PAUSE
START/
STOP
PLAY
A.DUB
T
W
Speaker
NOTES:
●Before performing the following steps, make sure that “TIME CODE” is set to “ON”. ( pg. 25, 28)
●Insert Editing is not possible on a tape recorded in the LP mode or on a blank portion of a tape.
●To perform Insert Editing while watching in the television, make connections. ( pg. 17)
1 Play back the tape, locate the
2 Press REW (3) until the
1 Play back the tape to locate the point where editing will start, then press PAUSE (9).
2 While holding A. DUB (D) on the remote control, press PAUSE (9). The “9D” and “MIC” indicators appear.
3 Press PLAY (U), then begin “narrating”. Speak into the microphone.
●To pause dubbing, press PAUSE (9).
4 To end Audio Dubbing, press PAUSE (9), then STOP (8).
To hear the dubbed sound during playback
Set “NARRATION” to “ON” or “MIX”. ( pg. 25, 28)
NOTES:
●Sound is not heard from the speaker during Audio Dubbing.
●When editing onto a tape that was recorded at
●If you dub onto a blank space on the tape, the sound may be disrupted. Make sure you only edit recorded areas.
●If feedback or howling occurs during TV playback, move the camcorder’s microphone away from the TV, or turn down the TV’s volume.
●If you change from
●During Audio Dubbing, when the tape moves to scenes recorded in the LP mode, scenes recorded in
●To perform Audio Dubbing while watching on the television, make connections. ( pg. 17)
●To perform Audio Dubbing with a video unit connected to the camcorder’s AV connector, first set “S/AV INPUT” to “ON” in VIDEO Menu. ( pg. 25, 28)
The “AUX” indication appears instead of “MIC”.
3 Press and hold INSERT (I) on the remote control, then press PAUSE (9). The “9I” indicator and the Time Code (min.:sec.) appear and the camcorder enters
4 Press START/STOP to begin editing.
●Confirm the insert at the time code you checked in step 1.
●To pause editing, press START/STOP. Press it again to resume editing.
5 To end Insert Editing, press START/STOP, then STOP (8).
NOTES:
●Program AE with special effects ( pg. 30) can be used to spice up the scenes being edited during Insert Editing.
●During Insert Editing, the date and time information changes.
●If you perform Insert Editing onto a blank space on the tape, the audio and video may be disrupted. Make sure you only edit recorded areas.
●During Insert Editing, when the tape moves to scenes recorded in the LP mode or a blank portion, Insert Editing stops. ( pg. 43)