JVC GR-D225 manual Main Unit

Page 33

 

 

CAUTIONS

EN 33

Main Unit

 

 

 

 

 

About moisture condensation

For safety, DO NOT…

 

You have observed that pouring a cold liquid into a glass

...open the camcorder’s chassis.

 

will cause drops of water to form on the glass’ outer

 

surface. This same phenomenon occurs on the head

...disassemble or modify the unit.

 

 

drum of a camcorder when it is moved from a cool place

...short-circuit the terminals of the battery pack. Keep it away

 

 

to a warm place, after heating a cold room, under

from metallic objects when not in use.

 

 

extremely humid conditions or in a place directly

...allow inflammables, water or metallic objects to enter the

 

 

subjected to the cool air from an air conditioner.

unit.

 

 

Moisture on the head drum can cause severe damage to

...remove the battery pack or disconnect the power supply

 

 

the video tape, and can lead to internal damage to the

while the power is on.

 

 

camcorder itself.

...leave the battery pack attached when the camcorder is not

 

 

 

 

in use.

 

Serious malfunctioning

Avoid using the unit…

 

 

 

 

If malfunctioning occurs, stop using the unit

...in places subject to excessive humidity or dust.

 

 

immediately and consult your local JVC dealer.

...in places subject to soot or steam such as near a cooking

 

stove.

 

 

 

...in places subject to excessive shock or vibration.

 

The camcorder is a microcomputer-controlled device.

...near a television set.

 

 

External noise and interference (from a TV, a radio,

...near appliances generating strong magnetic or electric

 

 

etc.) might prevent it from functioning properly. In such

fields (speakers, broadcasting antennas, etc.).

 

 

cases, first disconnect its power supply unit (battery

...in places subject to extremely high (over 40°C) or

 

 

pack, AC Adapter, etc.) and wait a few minutes and

extremely low (under 0°C) temperatures.

 

DO NOT leave the unit…

 

then re-connect it and proceed as usual from the

...in places of over 50°C.

 

beginning.

...in places where humidity is extremely low (below 35%) or

 

 

 

extremely high (above 80%).

 

 

 

...in direct sunlight.

 

 

 

...in a closed car in summer.

 

 

 

...near a heater.

 

 

 

To protect the unit, DO NOT…

...allow it to become wet.

...drop the unit or strike it against hard objects.

...subject it to shock or excessive vibration during transportation.

...keep the lens directed at extremely bright objects for long periods.

...expose the lens and viewfinder’s lens to direct sunlight.

...carry it by holding the LCD monitor or the viewfinder.

...swing it excessively when using the hand strap or the grip.

...swing the soft camera case excessively when the camcorder is inside it.

Dirty heads can cause the following problems:

...No picture during playback.

...Blocks of noise appear during playback.

...During recording, the Head Clog Warning indicator “ ” appears.

...Recording cannot be performed properly.

In such cases, use an optional cleaning cassette. Insert it and play back. If the cassette is used more than once consecutively, damage to the video heads may result. After the camcorder plays back for about 20 seconds, it stops automatically. Also refer to the cleaning cassette’s instructions.

If, after using the cleaning cassette, the problems still exist, consult your nearest JVC dealer.

Mechanical moving parts used to move the video heads and video tape tend to become dirty and worn out over time. In order to maintain a clear picture at all times, periodic check- ups are recommended after using the unit for about 1,000 hours. For periodic check-ups please consult your nearest JVC dealer.

REFERENCES

Image 33 Contents
To deactivate the demonstration, set Demo Mode to OFF  pg Dear CustomerLYT1418-001A EN Blue to N Neutral or Black Brown to L Live or Red Important for owners in the U.KBefore recording an important scene… Some DO’S and DON’TS on the Safe USE of EquipmentEN Contents Getting Started Advanced Features Provided Accessories How To Attach The Shoulder StrapGetting Started EN How To Attach The Core Filter for optional S-Video Cable PowerCharging The Battery Pack EN Getting StartedGrip Adjustment Using The Battery PackUsing AC Power About BatteriesDate/Time Settings Operation ModePower-Linked Operation Full Auto RecordingTo switch the recording mode, refer to pages 14 Brightness Adjustment Of The DisplayLoading/Unloading a Cassette Tripod MountingEN Video Recording Basic RecordingLCD Monitor And Viewfinder Tape Remaining TimeJournalistic Shooting Video Recording ENSelf Recording Time CodeEN Video Playback Normal PlaybackShuttle Search Blank SearchConnections To a TV Or VCR If using a VCR, go to . If not, go to stepWhite to Audio L Red to Audio R Yellow to Video To S-VIDEO To AV To SChanging The Menu Settings EN Menus for Detailed AdjustmentMenus with Sub Menus Zoom magnification will reset to 16X since digital zoom 16X When set to 16X while using digital zoom,For details on the procedure, refer to Snapshot For Brightness adjustment pg , Brightness Adjustment Of The Display  pg , Date/Time SettingsWhen the Menu Screen is closed after Demo Mode is turned on Sound Mode and Narration Playback MenusOFF / on Night Scope White LED LightTo deactivate Night-Scope Wipe Or Fader Effects Select OFF in . The effect indicator disappearsTo deactivate the selected effect Variable Shutter Speed 1/250 1/4000Motor Drive Mode EN Features for RecordingSnapshot For Video Recording Press SnapshotTo reset to Auto Focus Auto FocusManual Focus Iris Lock Exposure ControlTo return to automatic exposure control To return to automatic iris controlTo change the setting White Balance AdjustmentBacklight Compensation Brightness returns toDubbing To a VCR EN EditingTo use this camcorder as a player DV Connector Digital Dubbing Connection To a Personal Computer Video Playback pg Power pgLoading/Unloading a Cassette pg Video Recording pgPower EN TroubleshootingVideo Playback Video RecordingPower Switch is set to a HSet the Power Switch to M.  pg Advanced features Other problemsSubject is too bright HSet r to SPOTLIGHT.  pg Be avoidedPlaces subject to low temperature, images become dark Monitor fully.  pgTime Code is set to OFF HSet Time Code to ON.  pg , 16 Remaining power level High Exhausted Displays the battery remaining powerLCD Monitor EN CautionsMain Unit EN User Maintenance Cleaning The CamcorderSlide BATT.RELEASE 1 and remove the battery pack After UseAC Adapter CamcorderEN Index Indicators ConnectorsControls Other PartsDuring Video Recording IndexI t / M I 40 x W 1h40m 20 21 1555Connections Wide Mode Wide ModeDate/Time Menu ScreenVictor Company of Japan, Limited