JVC GZ-MC100US instruction manual Inserting/Removing a CF Card, Inserting/Removing an SD Card

16 EN GETTING STARTED

	Inserting/Removing a CF Card		5 To insert a CF card, firmly insert it as shown in the
			illustration.
			To remove a CF card, push the eject button twice.
You can use a CF card (CompactFlash card) as a
			● The eject button comes out by pushing it once. By pushing
recording medium in the CF slot.
			the eject button once again ejects the CF card.
The removable hard disk (provided) or Microdrive is a type
			6 Close the rear panel firmly until it locks.
of CF cards. See page 42 for the recommended media.
			NOTES:
			● Read the cautions on CF card. ( pg. 38, “Recording
			Medium”)
		OPEN	● Before using a new CF card, it is necessary to format the CF
			card. ( pg. 27)

Rear Panel

Eject Button

ATTENTION:

●Do not insert or remove the CF card while the camera is turned on, as this may cause the CF card to be corrupted or cause the camera to become unable to recognize whether or not the CF card is installed.

●Do not squeeze the external covers of the CF card.

CF Slot

Front

Terminals

1 Make sure the camera’s power is off.

2 Open the LCD monitor fully. (
pg. 18)

3 Slide and hold OPEN in the direction of the arrow B, then open the rear panel.

4 When the eject button is pulled out as shown in the illustration, push it once.

●The button is pushed in.

Inserting/Removing an SD Card

You can use an SD card as a recording medium in the SD slot. See page 42 for the recommended media.

Clipped edge	Write/Erase
	Protection Tab
SD Slot
	Terminals

SD card

1 Perform steps 1 – 3 in “Inserting/Removing a CF

Card”.