JVC GR-DVM5 manual Engagemode Vcrs RECORD-PAUSE, Start Editing, Stop Editing

EN67

Power Dial

	M
A	5S
OFF
Y
A
L
P

START/STOP button

T W

Remote Sensor

FADE/WIPE

EFFECT PAUSE

EDIT IN/OUT	R.A. EDIT ON/OFF
CANCEL	VCR REC STBY

Rewind button

Pause button

Stop button

IN OUT MODE 41 WH 0 0 : 2 5 ~ 0 2 : 0 5 P – –

2P 0 7 : 1 8 ~ 0 8 : 3 1 – –

3– – 0 3 : 3 3 ~ 0 5 : 5 3 B/W

4 0 9 : 3 0 ~ 1 3 : 1 5

5 1 5 : 5 5 ~ 1 6 : 2 0 – – – –

6– – – – : – – ~

7~

8~

TIME CODE	1 6	: 3 0
TOTAL	9	: 3 9

Random Assemble Editing menu

8 REGISTER ADDITIONAL SCENES Repeat steps 4 – 7 (☞ pg. 66).

•To change previously registered points, press CANCEL on the remote control. The registered points disappear, one at a time, from the most recently registered point.

•If you're not using Fade/Wipe or P.AE/Effects, repeat steps 4 and 5 only.

9 PREPARE SOURCE TAPE Rewind the tape in the camcorder to the beginning of the scene you want to edit and press the Pause button (6).

10 ENGAGEMODE VCR'S RECORD-PAUSE

Point the remote control towards the VCR’s remote sensor and press VCR REC STBY, or manually engage the VCR’s Record-Pause mode.

11 START EDITING

Press the START/STOP button on the camcorder. Editing proceeds as programed, right through to the end of the last registered scene.

•Pressing START/STOP on the remote control does not start editing.

•When dubbing is complete, the camcorder enters the Pause mode, and the recorder enters its Record-Standby mode.

•If you don’t register an Edit-Out point, the tape will be dubbed all the way to the end automatically.

12 STOP EDITING

Engage the Stop modes for the camcorder and the VCR.

To make the R.A. Edit counter display disap- pear, press R.A. EDIT ON/OFF on the remote control.

NOTES:

●Pressing R.A. EDIT ON/OFF on the remote control clears all settings registered during Random Assemble Editing.

●When the editing cable is connected to the Pause terminal during dubbing, make sure the remote control is pointed at the VCR’s sensor, and that the path between the two is unobstructed.

●If, during Random Assemble Editing, you press any button on the camcorder, its Record-Standby mode is automatically engaged.

●Random Assemble Editing may not function properly when using a tape including several duplicated Time Codes. (☞ pg. 23).