JVC GR-DVM5 manual These spots are not recorded

74EN

TROUBLESHOOTING(Cont.)

SYMPTOM POSSIBLE CAUSES CORRECTIVE ACTION

35.Colored bright spots appear all over the LCD monitor or the viewfinder.

35. •The LCD monitor or the	35.
viewfinder is made with
high-precision technology.
However, black spots or
bright spots of light (red,
green or blue) may appear
constantly on the LCD	————
monitor or the viewfinder.
These spots are not recorded
on the tape. This is not due
to any defect of the unit.
(Effective dots: more than
99.99 %)

36. The LCD monitor	36. •During playback of the	36.
indications are distorted.	unrecorded portion, High-
	speed Search and still	————
	playback, LCD monitor
	indications appear distorted.
	This is not a defect.
37. An unusual mark appears	37.	37. • Check the section of the
in the LCD monitor or the		manual that explains LCD
viewfinder.	————	monitor/viewfinder
		indications (☞ pgs. 79 –
		81).
38. An error indication	38. •A malfunction of some kind	38. • Remove the power supply
(E01 — E06) appears in	has occurred. In this case	(battery pack, etc.) and
the LCD monitor or the	the camcorder’s functions	press RESET button, and
viewfinder.	become unusable.	wait a few minutes for the
		indication to clear. When it
		does, you can resume using
		the camcorder.
		If the indication remains
		even though you repeat the
		above two or three times,
		please consult your nearest
		JVC dealer.
39. The charge indicator on	39. •The temperature of the	39. • To protect the battery, it is
the AC Charger Station	battery is extremely high/	recommended to charge it
does not light.	low.	in places with a temperature
	•Charging is difficult in places	of 10°C to 30°C (50°F to
	subject to extremely high/	86°F) (☞ pg. 11).
	low temperatures.
40. The recording mode	40. •This occurs when recording	40.
indicator “LP” blinks on	in the LP mode is not
the LCD monitor or the	available. After the indicator	————
viewfinder.	blinks, the recording mode
	switches to “SP” and
	recording goes on.
41. Picture does not appear	41. •The viewfinder is pulled out.	41. • Push the viewfinder back in.
on the LCD monitor.	•The LCD monitor's bright-	• Adjust the brightness of the
	ness setting is too dark.	LCD monitor (☞ pg. 24).

• If the monitor is tilted upward 180 degrees, open the monitor fully

(☞ pg. 25).

42.When the image is printed 42. •This is not a malfunction. from the printer, a black

bar appears at the bottom of the screen.

42.• By recording with Digital Image Stabilizer set to “ON” (☞ pg. 34) this can be avoided.