Stop Recording, Lens Cover Switch Power

JVC GR-AX910, GR-AX810 manual Stop Recording, Lens Cover Switch Power, Start/Stop Power indicator

“CAMERA”.

•The power indicator lights and the camcorder enters the Record–Standby Mode.

•The scene you’re aimed at appears on the viewfinder screen, with the word “PAUSE” superimposed upon it.

START SHOOTING

the lens cover, then set the power switch to

Slide the LENS COVER open/close switch to open

ENTER RECORD–STANDBY MODE

1 Slide EJECT to open the cassette holder, then insert the cassette with the label facing out. Press PUSH to ensure the holder is closed and locked.

NOTE:

You should already have performed the procedures listed below. If not, do so before continuing.

● Power (☞ pg. 8)

● Tape Length (☞ pg. 12)

● Recording Mode Setting (☞ pg. 13) ● Grip Adjustment (☞ pg. 14)

LOAD A CASSETTE

RECORDING

Basic Recording

LENS COVER

SWITCH

POWER

Start/Stop

The power indicator

25min

Tally lamp

Tape remaining time indicator

120min 119min 3min

1min (Blinking) 2min (Blinking)

0min (Blinking)

*min.....(Now calculating)

3 Press the RECORDING START/STOP button.

•The tally lamp lights while recording is in progress, and “REC ” appears in the viewfinder.

•If you want to turn the tally lamp off, see page 31.

STOP RECORDING

4 Press the RECORDING START/STOP button again to stop recording.

•The camcorder re-enters the Record-Standby mode.

NOTES:

●A cassette holder can’t be opened unless a power supply is attached.

●There may be a delay after you slide EJECT until the holder opens. Do not use force.

●The tape’s remaining time is displayed in the viewfinder as shown.

●The indicated remaining time is approximate.

●The time required to calculate the remaining tape length, and the accuracy of the calculation, may vary according to the type of tape used.

●The tape remaining time displayed in the viewfinder is correct only if the correct tape length has been selected (☞ pg. 12).

●“TAPE END” appears when the tape reaches its end, and the power goes off automatically if left in this condition for 5 minutes. “TAPE END” also appears when a cassette whose tape is already at its end is loaded.

●If the Record–Standby mode continues for 5 minutes without performing Zoom or any other operations, the camcorder’s power shuts off automatically. Set the Power switch to “POWER OFF”, and then back to “CAMERA” to turn the camcorder on again.

●If you’re recording on a cassette from the middle, use the RETAKE function (☞ pg. 18) to find the end of the last recording so you don’t erase any of it.

●The LENS COVER warning blinks for about 8 seconds when the camcorder is turned on, when the cover is closed.