JVC GR-D350AG manual Using The Battery Pack, Data Battery System, About Batteries

Page 13

GETTING STARTED EN 13

Using The Battery Pack

Using AC Power

Perform steps 2 3 in “Charging The Battery Pack”.

Maximum continuous recording time

Battery pack

LCD monitor

Viewfinder on

on

 

 

 

 

 

BN-VF707U*

1 hr. 30 min.

1 hr. 40 min.

 

 

 

BN-VF714U

3 hr.

3 hr. 25 min.

 

 

 

BN-VF733U

7 hr.

8 hr.

 

 

 

* Provided

 

 

NOTES:

Recording time is reduced significantly under the following conditions:

Zoom or Record-Standby mode is engaged repeatedly.

The LCD monitor is used repeatedly.

The playback mode is engaged repeatedly.

Before extended use, it is recommended that you prepare enough battery packs to cover 3 times the planned shooting time.

ATTENTION:

Before detaching the power source, make sure that the camcorder’s power is turned off. Failure to do so can result in a camcorder malfunction.

Data Battery System

You can check the remaining battery power and the recordable time.

1)Make sure the battery is attached and the Power Switch is set to “OFF”.

2)Open the LCD monitor fully.

3)Press DATA, and the battery status screen appears.

It is displayed for approx. 5 seconds if the button is pressed and released quickly, and for 15 seconds if the button is pressed and hold for several seconds.

If “COMMUNICATION ERROR” appears instead of the battery status even though you tried to press DATA several times, there may be a problem with your battery. In such a case, consult your nearest JVC dealer.

Perform step 4 5 in “Charging The Battery Pack”.

NOTE:

The provided AC Adapter features automatic voltage selection in the AC range from 110 V to 240 V.

About Batteries

DANGER! Do not attempt to take the batteries apart, or expose them to flame or excessive heat, as it may cause a fire or explosion. WARNING! Do not allow the battery or its terminals to come in contact with metals, as this can result in a short circuit and possibly start a fire.

To resume the original function of the accurate battery power indication

If the battery power indication differs from the actual operating time, fully charge the battery, and then run it down. However this function may not turn back if the battery was used for a long period of time under extremely high/low temperature condition or charged too many times.

GETTING STARTED

Image 13
Contents Dear Customer To deactivate the demonstration, set Demo Mode to OFF.  pgUse SP Standard mode for important video recordings We recommend cleaning your video heads before useFor safety and reliability Do not leave the unitSafety Precautions Page Wipe/Fader Effects Data BatteryProgram AE and Special Effects Backlight CompensationMake sure you only use cassettes with the Mini DV mark Before Using This CamcorderIt is recommended that you use JVC brand cassette tapes Quick Review Recording From The Middle Of a Tape Tape Remaining Time LCD Monitor And ViewfinderEN Getting Started IndexÃIndicators ConnectorsControls ÅOther PartsGetting Started 10 ENDuring Video Recording During Video PlaybackHow To Attach The Lens Cap Provided AccessoriesHow To Attach The Shoulder Strap Slide the strap guide fully towards the eyeletCharging The Battery Pack PowerSlide the battery pack upward while pressing With other equipmentData Battery System Using The Battery PackPerform steps 2 3 in Charging The Battery Pack About BatteriesLanguage Settings Operation ModePower-Linked Operation Auto/Manual ModeViewfinder Adjustment Date/Time SettingsBrightness Adjustment Grip AdjustmentTo protect valuable recordings Tripod MountingVideo Recording EN Basic RecordingTape Remaining Time LCD Monitor And ViewfinderZooming EN Video RecordingZoom Zoom OutQuick Review Time CodeThen start recording.PLAYBACK Display Minutes Seconds Frames Frames = 1 secondEN Video Playback Normal PlaybackVideo Playback EN If using a VCR , go to stepMake sure all units are turned off Shown in the illustrationVideo Recording Menus EN Menus for Detailed AdjustmentVideo Playback Menus Recording Menus Pg , Date/Time Settings Pg , Brightness Adjustment Of The DisplayOFF Time code is not displayed When set to OFF, the camcorder’s display disappears Sound Mode and NarrationPlayback Menus OFF / on26 EN Features for RecordingTape Night-ScopeManual Focus To reset to Auto FocusExposure Control Manual focus is recommended in situations listed belowIris Lock EN Features for RecordingTo return to automatic iris control Select Auto in stepTo change the setting White Balance AdjustmentSpot Exposure Control To lock the irisTo REC Select OFF in . The effect indicator disappearsSet WIPE/FADER to the desired mode.  pg To deactivate the selected effectEffects Features for Recording ENProgram AE, Effects And Shutter SportsEN Editing Dubbing To a VCRDigital Dubbing Equipped With a DV ConnectorTo use this camcorder as a recorder To use this camcorder as a playerIf you are using a Windows XP, you can use To a PC with a DV connector by usingConferences over the Internet, using a It is also possible to transfer still/moving imagesPower TroubleshootingAdvanced features Video RecordingOther problems EN TroubleshootingAppears when the date/time is not set Button is pressed while the Power Switch is setBuilt-in clock battery has run out ReplacementEN User Maintenance Cleaning The CamcorderCassettes Battery PacksLCD Monitor Main Unit EN CautionsAC Adapter Camcorder42 EN Tape Speed REC ModeTerms Recording CapacityMemo GR-D350AG