VIDEO RECORDING EN 19
Time Code
During recording, a time code is recorded on the tape. This code is to confirm the location of the recorded scene on the tape during playback.
Display
Minutes
Seconds
Frames*
(25 frames = 1 second)
12 : 34 : 2 4
* Frames are not displayed during recording.
If recording starts from a blank portion, the time code begins counting from “00:00:00” (minute:second:frame). If recording starts from the end of a previously recorded scene, the time code continues from the last time code number. If during recording a blank portion is left partway through the tape, the time code is interrupted. When recording is resumed, the time code starts counting up again from “00:00:00”. This means the camcorder may record the same time codes as those existing in a previously recorded scene. To prevent this, perform Recording From The Middle Of A Tape ( pg. 19) in the following cases;
●When shooting again after playing back a recorded tape.
●When power shuts off during shooting.
●When a tape is removed and
●When shooting using a partially recorded tape.
●When shooting on a blank portion located partway through the tape.
●When shooting again after shooting a scene then opening/closing the cassette holder cover.
Quick Review
Enables to check the end of the last recording.
1)Press QUICK REVIEW during the Recording- Standby mode.
2)Tape is rewound for about several seconds and played back automatically, then pauses in the
● Distortion may occur at start of playback. This is normal.
Recording From The Middle Of A Tape
1)Play back a tape or use Blank Search
( pg. 20) to find the spot at which you want to start recording, then engage the Still Playback mode. ( pg. 20)
2) Set the Power Switch to “REC” while pressing down the Lock Button located on the switch,
then start recording.PLAYBACK
VIDEO &RECORDING
NOTES:
●The time code cannot be reset.
●During
●The time code is displayed only when “TIME CODE” is set to “ON”. ( pg. 24)