JVC GR-D340E/EK manual Power, How To Attach The Lens Cap, Charging The Battery Pack

Connect the AC Adapter to the camcorder.

12 EN GETTING STARTED
How To Attach The Lens Cap	Power
To protect the lens, attach	This camcorder’s 2-way power supply system
the provided lens cap to the
	lets you choose the most appropriate source of
camcorder as shown in the
	power. Do not use provided power supply units
illustration.
	with other equipment.
NOTE:
	Charging The Battery Pack
To confirm the lens cap is on
correctly make sure the cap is
flush to the camcorder.	Battery pack mount
		PUSH
	Battery pack	BATT.
Place here during
shooting.		POWER/
How To Attach The Shoulder Strap	Arrow	CHARGE
		lamp

Follow the illustration.

1 Thread the strap through the eyelet.

2 Fold it back and thread it through the strap guide and the buckle.

●To adjust the length of the strap, loosen and then tighten the strap in the buckle.

3 Slide the strap guide fully towards the eyelet.

To DC	To AC outlet
connector

Power switch

Buckle AC Adapter (ex. AP-V17E)

Strap guide

1

Eyelet

2 2

1 Set the Power Switch to “OFF”.

2 With the arrow on the battery pack pointing downward, push the battery pack slightly against the battery pack mount a.

3 Slide down the battery pack until it locks in place b.

4

5 Connect the Power Cord to the AC Adapter. (AP-V14E only)

6 Plug the AC Adapter into an AC outlet. The

3POWER/CHARGE lamp on the camcorder blinks to indicate charging has started.

7 When the POWER/CHARGE lamp goes out, charging is finished. Unplug the AC Adapter from the AC outlet. Disconnect the AC Adapter from the camcorder.