22 EN VIDEO PLAYBACK
Playback Using The Remote | The following buttons are available only when |
the camcorder’s Power Switch is set to “PLAY”. | |
Control | B PAUSE Button |
| |
| ● Pauses the tape ( pg. 23) |
The
Installing The Battery
Up Button ( pg. 23)
C SLOW Rewind Button ( pg. 23) D REW Button
●Rewind/Reverse Shuttle Search on a tape ( pg. 20)
Left Button ( pg. 23)
E INSERT Button ( pg. 40)
F SHIFT Button ( pg. 23)
The remote control uses one lithium battery (CR2025).
1 Pull out the battery holder by pushing the lock tab.
2 Insert the battery in the holder, and be sure to have the “+” mark visible.
2
1
13
Lock tab
G DISPLAY Button ( pg. 21, 40) H SLOW Forward Button ( pg. 23) I PLAY Button
●Starts Playback of a tape ( pg. 20)
J FF Button
●Forward/Forward Shuttle Search on a tape ( pg. 20)
Right Button ( pg. 23)
K A. DUB Button ( pg. 40)
L STOP Button
3 Slide the holder back in until you hear a click.
Beam Effective Area (indoor use)
When using the remote control, be sure to point it at the remote sensor. The transmitted beam’s approximate effective distance for indoor use is
5 m. | Remote sensor |
NOTE:
The transmitted beam may not be effective or may cause incorrect operation when the remote sensor is directly exposed to sunlight or powerful lighting.
Buttons And Functions
●Stops the tape ( pg. 20)
Down Button ( pg. 23)
M EFFECT Button ( pg. 23)
N EFFECT ON/OFF Button ( pg. 23)
The following buttons are available when the camcorder’s Power Switch is set to “A” or “M”. o Zoom (T/W) Buttons
Zoom in/out ( pg. 18, 23)
(Also available with the Power Switch set to “PLAY”)
p START/STOP Button
Functions the same as the Recording Start/ Stop Button on the camcorder.
q S.SHOT Button
Functions the same as SNAPSHOT on the camcorder.
(Also available with the Power Switch set to “PLAY”)
A Infrared beam transmitting window
●Transmits the beam signal.