DISTRIBUTION AMPLIFIERS
INSTALLATION | 6 |
Step 1. Before you plug in the power cord into the unit, please verify that the voltage rating of 110V/220V on the FUSE CLIP located on the rear of the unit is the same as the power outlet.
OPERATION | 7 |
The DA1222AT will operate successfully as long as cables are attached properly and other technical specifications are followed. There are no other adjustments necessary to operate the unit.
ACCESSORIES | 8 |
Step 2. Connect the female end of the power cord to the DA1222AT and plug the male end into the power outlet. The power indicator LED on the front panel will turn ON. This indicates that the unit is operational.
Step 3. Connect the video output of the source (computer, or interface, or any other
NOTE: You may have to use an interface (DA1910SX or VA6855WM) with your source computer to provide the appropriate signal format type and to allow the use of a local monitor. Do not use a
Step 4. Connect the output channels of the DA1222AT to the display devices (i.e. monitors and/or projectors) using a cable less than 10 feet with the appropriate number of channels.
Step 5. Verify that the picture quality and bandwidth on all displays is good.
CONGRATULATIONS! YOU ARE DONE.
If you experience any problems, please call
international calls.
Model No.
TM1271
TM1272
TM1273
TM1274
DA1293FC
DA1294FC
CB4203MR
CB4206MR
CB4212MR
CB4225MR
CB4250MR
CHB4275MR
CB42100MR
CB42150MR
CB4406MR
CB4412MR
CB4425MR
CB4450MR
CB4475MR
CB44100MR
CB44150MR
MS8102CA
MS8104CA
MS8105CA
MS8112CA
MS8114CA
Description
TABLE MOUNT BRACKETS
1 U High, ½
1U High, ½
1U High, ½
1U High, ½
RACK/TABLE MOUNT HARDWARE
HIGH RESOLUTION
3 feet,
6feet,
12 feet,
25 feet,
50 feet,
75 feet,
100 feet,
150 feet,
SUPER HIGH RESOLUTION 5- CHANNEL COAX CABLE
6feet,
12 feet,
25 feet,
50 feet,
75 feet,
100 feet,
150 feet,
VGA TO RGB ADAPTER CABLES
6