JVC GR-DVL555, GR-DVL150, GR-DVL157 66 EN, Audio Dubbing, To hear the dubbed sound during playback

66 EN

Display

USING THE REMOTE CONTROL UNIT (cont.)

Audio Dubbing

Speaker

6e Audio Dub Standby mode

Power Switch

The audio track can be customized only when recorded in the 12-bit mode ( pg. 47).

NOTES:

●Audio Dubbing is not possible on a tape recorded in

16-bit audio, on a tape recorded in the LP mode or on a blank portion of a tape.

●To perform Audio Dubbing while watching on the television, make connections (  pg. 22).

1 Play back the tape to locate the point where editing will start, then press PAUSE (6).

2 While holding A.DUB (e) on the remote control, press PAUSE (6). “6e” appears.

3 Press PLAY (4), then begin “narrating”. Speak into the microphone.

•To pause dubbing, press PAUSE (6).

4 To end Audio Dubbing, press PAUSE (6), then STOP (5).

Remote sensor

Stereo microphone

A.DUB

PLAY

STOP

PAUSE

To hear the dubbed sound during playback . . .

.... set “12BIT MODE” to “SOUND 2” or “MIX” in the

Menu Screen ( pg. 50, 51).

NOTES:

●Sound is not heard from the speaker during Audio Dubbing.

●When editing onto a tape that was recorded at 12-bit, the old and new soundtracks are recorded separately.

●If you dub onto a blank space on the tape, the sound may be disrupted. Make sure you only edit recorded areas.

●If feedback or howling occurs during TV playback, move the camcorder’s microphone away from the TV, or turn down the TV’s volume.

●If you change from 12-bit to 16-bit in mid-recording and then use the tape for Audio Dubbing, it is not effective from the point where 16-bit recording began.

●During Audio Dubbing, when the tape moves to scenes recorded in the LP mode, scenes recorded in 16-bit

audio or a blank portion, Audio Dubbing stops ( pg. 83).

●To perform Audio Dubbing with a video unit connected to the camcorder’s AV connector, first set “S/AV INPUT”

to “ON” in the Menu Screen (GR-DVL557 only  pg. 50).