JVC GR-DVL157, GR-DVL150 EN71,  pg, When you use the LCD monitor outdoors in direct sunlight

Page 71

DETAILS

EN71

I T E M S

N O T E S

 

 

 

 

Power

Perform charging where the temperature is between 10°C and

( pg. 8)

35°C. 20°C to 25°C is the ideal temperature range for charging. If

 

the environment is too cold, charging may be incomplete.

Charging times are for a fully discharged battery pack.

Charging time varies according to the ambient temperature and the status of the battery pack.

To avoid interference with reception, do not use the AC Adapter near a radio.

Since the AC Adapter processes electricity internally, it becomes warm during use. Be sure to use it only in well-ventilated areas.

The following operation stops charging:

Set the Power Switch to “ ”, “ ” or “ ”.

Disconnect the AC adapter from the camcorder.

Unplug the AC adapter’s power cord from the AC outlet.

Detach the battery from the camcorder.

VIDEO

When you use the LCD monitor outdoors in direct sunlight, the

RECORDING

LCD monitor may be difficult to see. If this happens, use the

( pg. 16, 17)

viewfinder instead.

 

The cassette holder cannot be opened unless a power supply is

 

attached.

 

There may be a delay after you open the cassette holder cover until

 

the cassette holder opens. Do not use force.

 

Once the cassette holder is closed, it recedes automatically. Wait

 

until it recedes completely before closing the cassette holder cover.

 

When the Recording Start/Stop button is pressed, it may take a few

 

seconds before actual recording starts. “ ” starts rotating when

 

the camcorder actually starts recording.

 

The time required to calculate and display the remaining tape

 

length, and the accuracy of the calculation, may vary according to

 

the type of tape used.

 

“TAPE END” appears when the tape reaches its end, and the power

 

goes off automatically if left in this condition for 5 minutes. “TAPE

 

END” also appears when a cassette at its end is loaded.

Image 71
Contents Instructions AC Adapter until Dear CustomerIt is recommended that you Unit, first firmlySome DO’S and DON’TS on the Safe USE of Equipment Make sure you only use cassettes with the Mini DV mark Before recording an important sceneShoulder Strap Power CordRM-V717U UnitRelease the stoppers on both ends of the Core Filter How To Attach The Core FilterGetting Started ContentsSlide BAT. Release and pull out the battery pack PowerCharging the Battery Pack To Detach The Battery PackApproximate recording time Using the Battery PackUsing AC Power About BatteriesShoulder Strap Attachment Grip AdjustmentViewfinder Adjustment 10 ENDisplay Date/Time SettingsMENU/BRIGHT Wheel Power Lamp Lock Button Power Switch EN11Holder Cassette holder cover OPEN/EJECT Switch12 EN Loading/Unloading a CassetteEN13 Recording Mode SettingSet the tape recording mode depending on your preference To Unload a Memory Card Picture Quality Mode SettingLoading a Memory Card GR-DVL557/DVL555/DVL357/DVL355 onlyVideo Recording & Playback ContentsBasic Recording To Adjust The Brightness Of The Display16 EN Video RecordingSELF-RECORDING Operation ModeEN17 Journalistic ShootingZoom Out Slide the Power Zoom Lever towards T18 EN ZoomSet Light OFF/AUTO/ON as required Feature Video LightTo brighten the scene when natural lighting is too dim EN19Proper recording When a blank portion is recorded on a tape20 EN Time CodeEN21 To Control The Speaker VolumeVideo Playback Normal PlaybackUse the provided Cable Adapter If your TV/VCR has a 21-pin connector22 EN ConnectionsEN23 If using a VCR . . . go to step If not . . . go to stepPress Blank Search To cancel Blank Search midway24 EN Blank SearchDigital Still Camera C. Recording Playback Snapshot Recording Snapshot Mode Selection26 EN Basic Shooting SnapshotTo Delete Unwanted Still Images When unwanted still images are stored in the memoryWhen you do not want to hear the shutter sound, set EN27Auto Playback Power Switch to28 EN EN29 Index ScreenIndex Playback 10 / 50 Total number Images 30 ENJump Playback MENU/BRIGHT Wheel Jump Button DisplayTo Remove Protection Protecting ImagesEN31 To Protect AN ImageTo Select AN Image by Browsing 32 ENDeleting Images To Delete the Displayed ImageBefore doing the following, perform steps 1 through 3 on pg EN33To Delete ALL Images To Print ALL Still Images ONE Print for Each To Reset The Setting34 EN Dpof Screen To Reset The No. Of PrintsEN35 To Print by Selecting Still Images and NO. of PrintsYou can initialise a memory card anytime 36 ENInitialising a Memory Card For Recording Advanced FeaturesProgramme AE With Special Effects 38 ENFor Recording Night-ScopeSlow Slow Shutter EN39Gives recorded scenes a strobe effect Your recording looks like a series of consecutive snapshotsPicture Wipe or Dissolve Selection 40 ENFade/Wipe Effects FADE/WIPE SelectionMenu Effect EN41Fader And Wipe Menu Display Menu Screen 42 ENSnapshot For Video Recording Snapshot ButtonTo obtain correct focus Feature Auto FocusFeature Manual Focus EN43Iris Lock 44 ENExposure Control To Return To Automatic White Balance White Balance AdjustmentManual White Balance Operation EN45See pg EN Using Menus for Detailed AdjustmentFor Recording Menu If you have selected WIPE/FADER Program AE or W. BalanceMenu Screen Explanations EN47Activates the shutter sound effect  pg Factory setting isRecording. Also to activate the shutter sound effect  pg EN49 For Playback Menu Following procedure applies to all except Synchro Comp  pgPlayback Sound DisplayEN51 To use this camcorder as a player 52 ENDubbing Dubbing To a VCRVCR Playback deck Dubbing From a VCREN53 To use this camcorder as a recorder GR-DVL557 onlyFor GR-DVL557/DVL357/DVL157 Owners 54 ENEN55 Dubbing Images Stored In a Memory CardMemory Card GR-DVL557/DVL555/DVL357/DVL355 only 56 ENDubbing Images Recorded On a Tape To a Images can be dubbed from a tape to a memory cardTab Using the Remote Control UnitInstalling The Batteries EN5758 EN EN59 Feature Slow-Motion PlaybackFeature Frame-By-Frame Playback Feature Playback Special EffectsDown SHIFT, press Left, Right, Up Feature Playback Zoom60 EN Press Play 4 to find the scene of interestVCR Recording deck EN61SET REMOTE/VCR Code VCR other than above JVC VCR equipped with a remote pause connector62 EN Make ConnectionsEditing Menu EN63Select Scenes Automatic Editing to VCR 64 ENDiagnosing VCR/CAMCORDER Timing Adjustment of VCR/CAMCORDER TimingFor More Accurate Editing EN65Audio Dubbing Set 12BIT Mode to Sound 2 or MIX Menu Screen  pgSpeaker 6e Audio Dub Standby mode Power Switch 66 ENEN67 Lock Button Power Switch Display Remote sensorInsert Editing Set the VIDEO/DSC switch to DSC Using DV cableAUsing USB or PC connection cable Using DV cableDigital Printer Connection To a Video Unit Equipped With a DV ConnectorPower Switch To DV Core filter DV cable optional Connector EN69References 70 EN pg When you use the LCD monitor outdoors in direct sunlight,Cassette holder cannot be opened unless a power supply is EN71Corrective Action 72 ENEN73 74 EN TroubleshootingEN75 76 EN Press Push Here to close the cassette holder User MaintenanceAfter Use Cleaning The Camcorder Turn off the camcorder5 6 78 ENEN79 Standard in order of quality 80 ENAppears and blinks during shooting.  pg EN81 Bright Displays the brightness of the LCD Displays the sound modeLevel indicator moves Displays the date LCD Monitor/Viewfinder Indications During Video PlaybackIndications Function EN83Appears, the memory card is corrupted Switch is set to pg PossibleTo avoid hazards To prevent damage and prolong service lifeEN85 86 EN Serious malfunctioning EN87To protect the unit, do not About moisture condensationTerms 88 ENTime Code  pg , 49, 50 EN89For Digital Video Camera 90 ENFor General EN91 For ConnectorsEG/EK 0101HOV*UN*YP