JVC GR-AXM500 Transmitted beam effective area, Interval Timer Indicator, Rec Time Indicator

Transmitted beam effective area

15° 5m

30°

15° 30 ° Remote sensor

When using the remote control, be sure to point it at the remote sensor. The above illustration shows the approximate transmitted beam effective area for indoor use.

The transmitted beam may not be effective or may cause incorrect operation outdoors or when the remote sensor is directly exposed to sunlight or powerful lighting.

		EN	65
FEATURE:	Self-Timer, Animation and Time-Lapse
PURPOSE:	The remote control lets you set/release
	Interval Timer and Rec Time functions
	as well as the Menu Screen.
OPERATION:	Self-Timer
	1) Set
	Instead of performing steps 1 through
	4 on pg. 40 (“Self-Timer”), press INT.
	TIME on the remote control. Each
	time INT. TIME is pressed, the
	Interval Timer indicator appears,
	changing in the following order: 15S,
	30S, 1MIN, 5MIN and No indication
	(off).
	2) Release
	Instead of setting “INT. TIME” to
	“OFF” in the Menu, press INT. TIME
	on the remote control until the
	Interval Timer indicator disappears.
	Animation
	1) Set
	Instead of performing steps 1 and 2
	on pg. 41 (“Animation”), press REC

Interval Timer Indicator

1MIN	INDEX
1 2S

LCD monitor or viewfinder

Index Code Marking

TIME on the remote control. Each

time REC TIME is pressed, the Rec

Time indicator appears, changing in

the following order: 1/4S, 1/2S, 1S,

5S and No indication (off).

2) Release

Instead of using the Menu in step 5

on pg. 41, press REC TIME on the

remote control until the Rec Time

indicator disappears.

Time-Lapse

Rec Time Indicator

START/STOP

VISS

INT. TIME

REC TIME

RM-V709U (provided)

	1) Set
	Instead of performing steps 1 through
	3 on pg. 41 (“Time-Lapse”), press
	INT. TIME and REC TIME on the
	remote control. Each time INT. TIME
	is pressed, the Interval Timer
	indicator appears, changing in the
	following order: 15S, 30S, 1MIN,
	5MIN and No indication (off). Each
	time REC TIME is pressed, the Rec
	Time indicator appears, changing in
	the following order: 1/4S, 1/2S, 1S,
	5S and No indication (off).
	2) Release
	Instead of using the Menu in step 5
	on pg. 41, press INT. TIME and REC
	TIME on the remote control until the
	indicators disappear.
NOTE:	Also refer to pgs. 40 and 41.
FEATURE:	Index Code Marking
PURPOSE:	To give you automatic access to any
	selected point on a recording.
OPERATION:	1) Press VISS once to place the index
	code. “INDEX” blinks during
	marking.
NOTE:	If VISS is pressed during Record-
	Standby mode, the mark is placed
	where START/STOP is pressed.