72 EN | INDEX Indications (cont.) | ||
| Indications | Function |
|
|
|
|
|
|
| ● Appears when the date/time is not set. | ( pg. 9) |
| SET DATE/TIME! | ● Appears when the |
|
| previously set date/time is erased. Consult your nearest JVC dealer | ||
|
| ||
|
| for replacement. |
|
|
|
| |
| LENS CAP | Appears for 5 seconds after power is turned on if the lens cap is attached. | |
|
|
| |
| A. DUB ERROR! | Appears if Audio Dubbing is attempted on a blank portion of a tape. | |
|
| ( pg. 58) | |
|
|
| |
|
|
| |
| A. DUB ERROR! | ● Appears if Audio Dubbing is attempted on a tape recorded in the LP | |
| <CANNOT DUB | mode. | ( pg. 58) |
| ON AN LP RECORDED | ● Appears if Audio Dubbing is attempted on a tape recorded in | |
| TAPE> | ||
| audio. | ( pg. 58) | |
| <CANNOT DUB | ||
| ● Appears if A. DUB (e) on the remote control is pressed when the erase | ||
| ON A 16BIT | ||
| protection tab is set to “SAVE”. | ( pg. 58) | |
| RECORDING> | ||
| <CHECK TAPE’S ERASE |
|
|
| PROTECTION SWITCH> |
|
|
|
|
| |
| MEMORY IS FULL | Appears when the |
●Appears if the
on the tape to the | ( pg. 47) |
| ● Appears in the following cases when dubbing still images stored in the |
COPYING FAILED | |
– when condensation occurs. |
–when no tape is loaded.
–when the erase protection tab is set to “SAVE”.
–when a tape in another format is loaded.
| – when the tape ends. | ( pg. 46) | ||
|
|
| ||
NO IMAGES STORED | Appears if there are no images stored in the |
| ||
Power Switch is set to “ | ” and the VIDEO/DSC Switch is set to “ | ”. | ||
| ||||
|
|
| ||
E01 — E06 | The error indications (E01 — E06) show what type of malfunction has |
| ||
occured. When an error indication appears, the camcorder turns off |
| |||
UNIT IN SAFEGUARD | automatically. Remove the power supply (battery, etc.) and wait a few |
| ||
MODE REMOVE AND |
| |||
minutes for the indication to clear. When it does, you can resume using the | ||||
REATTACH BATTERY | ||||
camcorder. If the indication remains, consult your nearest JVC dealer. |
| |||
|
|