JVC GR-DVL9000 manual Recording From The Middle Of a Tape, Start Search, Engage Still Mode

20ENRECORDING

Recording From The Middle Of A Tape

BasicRecording(Cont.)

When removing a tape on which you were recording, or when you resume recording on a tape after playing back the recording previously made (without taking the tape out between recordings), perform this proce- dure.

Stop button

Play/Pause button

Rewind button

Fast-forward button

Lock button

		P
		L
		A
		Y
5S	M	AOFF

Power lamp

Power Dial

START/STOP button

PLAY

OFF

A

M

5S

1 SELECT OPERATION MODE

Turn the Power Dial to “PLAY” while pressing down the lock button located on the dial.

•The power lamp comes on.

2 PULL OUT VIEWFINDER OR OPEN LCD MONITOR

Pull out the viewfinder fully or open the LCD monitor to approx. 90° degrees.

3 START SEARCH

Press 4/6, then press 2 or 3. Watch in the viewfinder or the LCD monitor for the spot where you want to begin recording.

4 ENGAGE STILL MODE

Once you find the spot at which you want to start recording, press 4/6 twice to engage the Still mode.

5 START RECORDING

Turn the Power Dial to any operation mode except “PLAY” and “OFF”, then press START/ STOP.

•Start recording from a point prior to the end of the last recording. A few seconds of the end of the last recording will be erased.

NOTE:

If you start recording from the end of the previous recording leaving no blank space, there may be situations where a clean transition is not possible.