JVC GR-DVM76 instruction manual Cause damage.
pg, Re-insert it, then check if

EN 87

40. Picture does not appear on the		40. •The viewfinder is pulled out.		40. •Push the viewfinder back in.
	LCD monitor.		•The LCD monitor’s brightness		•Adjust the brightness of the
			setting is too dark.		LCD monitor. ( pg. 13)
					•If the monitor is tilted
					upward 180 degrees, open
					the monitor fully. ( pg. 13)
41.	Images on the LCD monitor	41.	•The speaker volume is too	41.	•Turn the speaker volume
	are jittery.		great.		down. ( pg. 22)
42.	The LCD monitor, the	42.		42.	•Wipe them gently with soft
	viewfinder and the lens have		—		cloth. Wiping strongly can
	become dirty (ex. fingerprints).				cause damage. ( pg. 91)
43.	Time code does not appear.	43.	•“TIME CODE” is set to	43.	•Set “TIME CODE” to “ON”.
			“OFF”.		( pg. 38, 49, 52)
44.	An unusual mark appears.	44.		44.	•Check the section of the
			—		manual that explains LCD
					monitor/viewfinder
					indications. ( pg. 96 – 99)
45.	An error indication (E01, E02	45.	•A malfunction of some kind	45.	•Remove the power supply
	or E06) appears.		has occurred. In this case the		(battery pack, etc.) and wait a
			camcorder’s functions		few minutes for the
			become unusable.		indication to clear. When it
					does, you can resume using
					the camcorder.
					If the indication remains
					even though you repeat the
					above two or three times,
					please consult your nearest
					JVC dealer. Do not eject the
					cassette. This will cause
					damage to the tape.
46.	An error indication (E03 or	46.	•A malfunction of some kind	46.	•Eject the cassette once and
	E04) appears.		has occurred. In this case the		re-insert it, then check if the
			camcorder’s functions		indication clears. When it
			become unusable.		does, you can resume using
					the camcorder.
					If the indication remains
					even though you repeat the
					above two or three times,
					please consult your nearest
					JVC dealer.