48
EN
USING
THE
REMOTE
CONTROL
UNIT
(cont.)
Power Switch
REW (2) Button
FF (3) Button 
PLAY/PAUSE (4/6) Button
STOP (5) Button
COUNTER R/M Button
Display
w |
|
| Insert editing | ||
|
|
|
|
| |
|
|
|
|
| indicator |
| M 0 : 12 : 34 |
|
|
| Tape Counter |
|
|
|
| ||
|
|
|
|
|
|
Remote sensor
START/STOP
Insert Editing
You can record a new scene onto a previously recorded tape, replacing a section of the original recording with minimal picture distortion at the in- and
NOTE:
Use the
1 SELECT OPERATION MODE Set the Power Switch to “PLAY”.
2 FIND EDIT-OUT POINT
Play back the tape, locate the point and press PAUSE on the camcorder or the remote control.
3 RESET COUNTER
Press and hold COUNTER R/M for more than
1 second to reset the tape counter, then press again for less than 1 second so that “M” appears.
4 FIND EDIT-IN POINT
Press REW to go a little beyond the beginning of the scene you want to replace, press PLAY to view the recorded tape, and press PAUSE exactly at the point where the new scene should start.
5 ENGAGE INSERT EDITING MODE Press and hold INSERT, and without releasing INSERT, press and release PAUSE. The Insert Editing mode is engaged. When the scene the camcorder is aimed at appears on the screen, go to the next step.
6 BEGIN INSERT EDITING
Press START/STOP. When the counter reaches “0:00:00”, editing stops automatically and the camcorder enters the
7 END INSERT EDITING
Press STOP.
NOTES:
● During Insert Editing, the original audio will be heard |
from the speaker. |
● After step 5, Retake (☞ pg. 17) can be performed. |
● The tape may stop slightly before or after the designated |
end point, and noise bars may appear. Neither indicates |
a defect in the unit. |
REW
PAUSE
STOP
● Only the video signal is recorded in the Insert Editing |
mode. |
INSERT