JVC GR-AXM405, GR-AXM205 manual Select Scenes, Start Source Playback, Register END of Scene

46EN

USINGTHEREMOTECONTROLUNIT(cont.)

Remote sensor

SELECT SCENES

4 START SOURCE PLAYBACK

Press PLAY, then press ON/OFF on the remote control. Make sure to point the remote control at the camcorder’s remote sensor.

•The R.A. Edit counter display appears.

5 REGISTER BEGINNING OF SCENE Press REW or FF to locate the beginning of the scene you want, then press IN/OUT to register that point.

•The data appears under “IN” on the display.

6 REGISTER END OF SCENE

Power Switch

REW

FF

Press REW or FF to locate the end of the scene and press IN/OUT to register it.

•The data appears under “OUT” on the display. •The total time of the registered scene(s) is displayed

at the bottom of the screen.

PLAY

PAUSE CANCEL

IN/OUT

ON/OFF

RM-V700U (provided with GR-AXM405, optional for GR-AXM205)

1	IN	OUT
	0:00:25	- - :- - :- -
2
3
4
5
6
7
8		0:00:25
COUNTER
TOTAL		0:00:00
1	IN	OUT
	0:00:25	0:01:05
2	0:03:18	0:03:31
3	0:02:33	0:02:53
4	0:04:11	- - :- - :- -
5
6
7
8		0:04:11
COUNTER
TOTAL		0:01:13

7 REGISTER ADDITIONAL SCENES Repeat steps 5 and 6 for each additional scene (as many as 8).

8 MAKE CORRECTIONS (IF NECESSARY) Press CANCEL during steps 5 and 6 to erase the most recently registered point.

NOTES:

●There must be at least one second between an in-point and its corresponding out-point.

●To ensure correct operation, there should be at least

15 seconds between an out-point and the next in-point.

●Blank portions of a tape cannot be registered as in-points or out-points.

●If it takes more than 5 minutes to search for an in-point, the VCR’s Record-Pause mode is cancelled and editing does not take place.

●Pressing ON/OFF clears all in- and out-points from memory.

●Leave a small margin for error around each in-point to ensure the scene is recorded in its entirety.

●Turning off the camcorder’s power erases all registered in- and out-points.