SkyLink 91562-01, 91561-01 Receiver Installation, Vehicle Preparation, For V-Rodmodels only

RECEIVER INSTALLATION

Kits 91558-01A and 91562-01 only

1.Unplug the power cord from the garage door drive unit to prevent door activation during installation.

2.Select an unswitched 110V power outlet in the garage located either highest in the garage, closest to the front of the garage, or both. Plug the Harley-Davidson remote control garage door opener receiver (14) into this outlet.

NOTE

For some brands of garage door opener systems, it may be necessary to plug in the Harley-Davidson receiver at a location some distance from the door opener. With those systems, if the Harley-Davidson receiver is plugged in too close to the original opener receiver, the effective trans- mission range may be significantly reduced on both sys- tems.

3.Find the two garage door activation switch terminals at one of the following locations:

•The existing wall-mounted, hard-wired garage door opener button.

•The garage door drive unit to which the garage door opener button is connected.

4.See Figure 27. Fasten the stripped end of the Harley- Davidson garage door opener receiver cable assembly

(15)to the door opener terminals that activate the door opener drive unit. Refer to the door opener manufacturer's documentation for terminal locations and connections.

NOTE

Do not remove the wires originally connected to the door opener button or drive unit terminals.

5.Assemble and install the garage door opener button or door opener drive unit in the original location.

6.Route the Harley-Davidson garage door opener receiver cable assembly connected in Step 4 to the power outlet selected in Step 2.

7.See Figure 1. Plug the connector on the Harley-Davidson garage door opener receiver cable assembly into the back of the Harley-Davidson garage door opener receiver in the location shown.

8.Plug the garage door opener receiver into the selected power outlet. Plug the power cord from the garage door drive unit into the power outlet.

is06654

Figure 1. Garage Door Opener Receiver, Back View

9.Press the wall-mounted garage door opener button to test the button operation.

VEHICLE PREPARATION

NOTE

For vehicles equipped with security siren:

•Verify that the Hands-Free Fob is present.

•Turn the ignition key switch to IGNITION.

For V-Rod models only:

Remove the air box aluminum cover per service manual instructions.

For EFI models EXCEPT V-Rod:

To prevent spray of fuel, purge system of high-pressure fuel before supply line is disconnected. Gasoline is extremely flammable and highly explosive, which could result in death or serious injury. (00275a)

Follow service manual instructions to purge the fuel supply of high pressure gasoline and remove the fuel supply line.

For ALL vehicles with main fuse:

To prevent accidental vehicle start-up, which could cause death or serious injury, remove main fuse before pro- ceeding. (00251b)

1.Refer to the service manual and follow the instructions to remove the main fuse.

All models except V-Rod:Remove and retain the seat and all mounting hardware.

For vehicles with main circuit breaker:

To prevent accidental vehicle start-up, which could cause death or serious injury, disconnect negative (-) battery cable before proceeding. (00048a)

1.Refer to the service manual and follow the instructions to remove the seat and disconnect the negative (black) bat- tery cable from the negative (-) battery terminal. Retain all seat mounting hardware.

For Carbureted Models:

Gasoline can drain from the carburetor fuel line when disconnected from fuel valve fitting. Gasoline is extremely flammable and highly explosive, which could result in death or serious injury. Wipe up spilled fuel immediately and dispose of rags in a suitable manner. (00256a)

2.Turn the fuel supply valve to OFF. Remove the fuel line from the valve.

-J02028 2 of 16