SkyLink 91561-01 Transmitter Installation, For Dyna, Softail and Sportster models, Dyna Models

For Dyna, Softail and Sportster models:

is06667

When servicing the fuel system, do not smoke or allow open flame or sparks in the vicinity. Gasoline is extremely flammable and highly explosive, which could result in death or serious injury. (00330a)

3.The fuel tank must be removed or slightly raised to access wiring underneath. See the correct section (Carbureted or EFI Engine) of the service manual for fuel tank bolt removal instructions.

If the fuel tank must be removed, follow the instructions in the service manual to remove the instrument console (if equipped) from the fuel tank before removing the tank.

TRANSMITTER INSTALLATION

Kits 91558-01A and 91561-01 only

NOTE

Transmitter effective range may vary between motorcycle models. For best garage door opener range, position the transmitter on the motorcycle as far as possible from large metal surfaces.

For best garage door opener performance, keep the trans- mitter and wires as far from vehicle heat sources as possible

Do not cover the view of the circuitry on the transmitter when fastening the foam tape retainer pad to the transmitter or mounting the transmitter to the vehicle. A red LED on the cir- cuitry side must remain visible for programming the receiver- transmitter. For best adhesion, use isopropyl alcohol to clean the surfaces to which the tape pad will mount.

1.See Figure 27. Remove the liner from the adhesive backing on one side of the tape pad (3). Carefully position the pad to the plastic casing of the transmitter (1), and press firmly into place.

2.Find specific model instructions in the sections that follow.

Dyna Models

1.Remove the fuel tank mounting bolts. See the correct section (Carbureted or EFI Engine) of the service manual.

2.See Figure 2. Use cable straps to fasten the transmitter to the Dyna wire harness (3), located under the seat and near the battery compartment. Route the transmitter wires forward along the right side of the frame.

Proceed to the Harness Connection section.

2

3

1

1.Orange/white wire

2.Ground connection

3.Strap transmitter to wire harness

Figure 2. Transmitter Mounting (Dyna)

1999 and Earlier Softails

1.Remove the fuel tank mounting bolts. See the correct section (Carbureted or EFI Engine) of the service manual.

2.See Figure 3. Remove the ground screw (1), located on the top of the frame, under the seat near the fuel tank.

3.See Figure 27. Use cable straps (8) from the kit to fasten only the transmitter case and the short section of conduit to the motorcycle wires leading forward toward the headlamp.

Proceed to the Harness Connection section.

is06668

1

3

2

1.Ground connection

2.Garage opener transmitter

3.Orange/white wire

Figure 3. Transmitter Mounting (1999 and Earlier Softails)

-J02028 3 of 16