is06727
2 |
1 |
1.White and yellow headlamp wires
2.Cut headlamp wire casing to access wires
Figure 25. White and Yellow Wire Optional External Splice
Location (Sportster Models)
3.Cut the yellow and white wires in the headlamp housing several inches from the headlamp connector. Cut excess length from the yellow and white transmitter wires if necessary. Cut to allow enough wire to easily strip and splice the wires.
4.See Figure 15, the 1 into 1 splice configuration. Use a blue sealed splice connector (Figure 27, Item 5) from the kit to splice the white transmitter wire to the white head-
lamp wires. Use the remaining blue sealed splice con- nector to splice the yellow transmitter wire to the yellow headlamp wires.
5.Proceed to the Receiver and Transmitter Programming section to program the garage door opener controls.
V-Rod Models
1.Cut the yellow and white wires in the main vehicle harness headlamp circuit at an accessible point several inches from the headlamp connector. Cut excess length from the yellow and white transmitter wires if necessary. Trim back the transmitter wire harness casing as needed to assist splicing. Cut to allow enough wire to easily strip and splice the wires.
2.See Figure 27. Slide the woven wire conduit (9) from the kit over the yellow and white transmitter wires.
3.See Figure 15, the 1 into 1 splice configuration. Use a blue sealed splice connector (Figure 27, Item 5) from the kit to splice the white transmitter wire to the white head- lamp wires. Use the remaining blue sealed splice con- nector to splice the yellow transmitter wire to the yellow headlamp wires.
4.Slide the woven wire conduit over the yellow and white wire connections after splicing.
5.Install the front left louvered cover onto the motorcycle.
6.Proceed to the Receiver and Transmitter Programming section to program the garage door opener controls.
13 of 16 |
