SkyLink 91562-01 and Later Sportster Models, FLHR Touring Models, Transmitter mounting location

is06715

2

3

1

is06716

1.Transmitter mounting location

2.Wires to headlamp

3.Ignition module

Figure 7. Transmitter Mounting and Wire Routing, (2003

or Earlier Sportster Models)

2004 and Later Sportster Models

1.Remove the fuel tank. See the correct section (Carbureted or EFI Engine) of the service manual.

2.Remove the electrical side cover, located on the left side of the motorcycle near the battery.

3.See Figure 27. Position the transmitter (1) behind the electrical side cover. Orient the transmitter so the printed circuit side faces away from the battery, and fasten the transmitter to the wire harness next to the main fuse holder using cable straps (8) from the kit.

Proceed to the Harness Connection section.

FLHR Touring Models

1.Remove the headlamp from the nacelle per the instructions in the service manual.

2.Remove the liner from the adhesive backing of the tape pad on the transmitter.

3.See Figure 8. Mount the transmitter to the right side of the frame near the fork tube.

Proceed to the Harness Connection section.

Figure 8. Transmitter Mounting Near Fork Tube (FLHR)

FLHT, FLHX and FLTR Touring Models;Trike Models

1.Remove the outer fairing per the instructions in the service manual.

2.Remove the liner from the adhesive backing of the tape pad on the transmitter.

3.See Figure 9 (FLHT, FLHX models) or Figure 10 (FLTR models). Mount the transmitter to the upper inside of the fairing.

Proceed to the Harness Connection section.

is06717

1

4

	2
6	3
	5

1.Mount transmitter to fairing

2.Headlamp connector

3.Orange/white wire

4.Black wire

5.White wire

6.Yellow wire

Figure 9. Wires for Transmitter Connections (FLHT/X)

-J02028 5 of 16