SkyLink 91562-01 Power Connections Sportster Models, Wire Splice Locations 2002-2003 V-Rod

NOTE

On some Sportster models the ignition module must be removed to access the orange/white wire in the main harness.

1.See Figure 20. Carefully slice open an area of the main harness wrap inside the electrical side cover or under the seat at an accessible point, and cut an orange/white main harness power lead.

is01106

1

2

1.Left side cover containing circuit breaker silver terminal (red wire)

2.Stock wire harness (orange/white wire)

Figure 20. Power Connections (Sportster Models)

2.Pull only the orange/white wire out of the longer piece of conduit on the garage door opener wire harness. Cut the excess length from the orange/white wire to within easy reach of the cut orange/white wires inside the side cover or under the seat.

3.See Figure 15, the 2 into 1 splice configuration. Use a red sealed splice connector (Figure 27, Item 4) from the kit to splice the garage door opener wire harness power lead to the main harness orange/white wires per the instructions in the service manual appendix.

4.Proceed to the Yellow and White Lead Connections section for the specific model.

2002-2004 V-Rod Models

NOTE

Electrical connectors are identified in the service manual by the number and letter shown here within brackets.

1.See Figure 21 or Figure 22. Cut the orange/white main vehicle harness wire near the unused position lamp con- nector [29A] (1).

2.Pull only the orange/white wire out of the longer piece of conduit on the garage door opener wire harness. Cut the excess length from the orange/white wire to within easy reach of the cut orange/white wires at connector [29A].

3.See Figure 15, the 2 into 1 splice configuration. Use a red sealed splice connector (Figure 27, Item 4) from the kit to splice the garage door opener wire harness power lead to the main harness orange/white wires per the instructions in the service manual appendix.

4.Proceed to the Yellow and White Lead Connections section for the specific model.

is06729

2

3

1

1.Connector [29A] with orange/white wire

2.White headlamp wire

3.Yellow headlamp wire

Figure 21. Wire Splice Locations (2002-2003 V-Rod)

is06730

2

1

1.Connector [29A] with orange/white wire

2.Headlamp harness

Figure 22. Wire Splice Locations (2004 V-Rod)

2005 and Later V-Rod Models

NOTE

Electrical connectors are identified in the service manual by the number and letter shown here within brackets.

1.See Figure 23. Cut the orange/white main vehicle har- ness wire near the headlamp pin connector [38A] (1).

2.Pull only the orange/white wire out of the longer piece of conduit on the garage door opener wire harness. Cut the excess length from the orange/white wire to within easy reach of the cut orange/white wires at connector [38A].

3.See Figure 15, the 2 into 1 splice configuration. Use a red sealed splice connector (Figure 27, Item 4) from the kit to splice the garage door opener wire harness power lead to the main harness orange/white wires per the instructions in the service manual appendix.

4.Proceed to the Yellow and White Lead Connections section for the specific model.

-J02028 11 of 16