Manuals / Delta Electronics / Computer Equipment / Network Card

Delta Electronics PG-04 Installation, Insert 3 PCB supports into control board, For 1-5HP

Models: PG-04

1 6

Download 6 pages 32.12 Kb

Page 5

Image 5

1-5 Installation

For 1-5HP

For 7.5 HP and above

Step 1: Insert 3 PCB supports into control board.

Step 2: Press the PG card on the control board to be fixed to tighten the 3 screws with a torque of 4-6kgf-cm. If the PG card is not fixed on the control board, it may cause screw idle running and cannot turn the screw into supports.

Page 5

Image 5

Delta Electronics PG-04 Installation, Insert 3 PCB supports into control board, For 1-5HP, For 7.5 HP and above

Contents

1-2 Explanations of the terminals of PG-04 Card 1-1 PG-04 AppearanceA1 B1 Z1, Z1 A2, A2 B2, B2 PG-04 Pulse Generator Card for VFD-V Series Instruction Sheet2. Recommended wire size 0.21~0.81mm2 AWG24~AWG18 3. Wire length 1-3 Wiring NotesMax. Wire Length Wire GaugeLine driver encoder 1-4 Wiring ExamplesWiring Diagram W 3~ Recommended Wiring for ResistorsWiring Diagram Line driver encoderStep 1 Insert 3 PCB supports into control board 1-5 InstallationFor 1-5HP For 7.5 HP and above2007-07-16 1-6 The corresponding output types of encoder5011614303-G4E3 Output Types of the Encoder