Installation
Instructions
BERWICK™7430.101
MONOBLOCK LAVATORY FAUCET with
Speed Connect™ Drain
Congratulations on purchasing your American Standard faucet with Speed Connect drain, a feature found only on American Standard faucets.
Speed Connect Drain*
•Fewer parts, installs in less time•Never needs adjustment
•Guaranteed to seal properly the first time, every time.Certified to comply with ANSI A112.18.1
M 9 6 8 6 4 1
*Your new American Standard faucet is designed to work only with the Speed Connect drain.
To ensure that your installation proceeds
Recommended tools
Screwdriver | Channel Locks | Adjustable Wrench | Tubing Cutter |
1 |
|
| Turn off hot and cold water |
| INSTALL FAUCET | CAUTION | |
| supplies before beginning. | ||
|
|
|
|
Seat SEAL (1) into under side of ESCUTCHEON RING (2).
Seat ESCUTCHEON RING (2) with collar facing up into groove in faucet base.
Feed FAUCET SUPPLIES (3), MOUNTING STUD (4) and DRAIN CABLE ASSEMBLY (8) through ESCUTCHEON RING (2) and the mounting hole of lavatory or mounting surface. Figure A.
From below, push GASKET (7) and RETAINING WASHER (5) onto MOUNTING STUD (4). Secure Faucet with MOUNTING NUT (6), pulling faucet to front of sink, so SUPPLIES (3) rests against mounting hole. Before final tightening, make sure collar on MOUNTING NUT (6) is seated into RETAINING WASHER (5). Figure B.
Adjust Faucet so that it is centered. Tighten MOUNTING NUT (6) to complete faucet mounting.
Figure A
GROOVE (FAUCET BASE)
2
COLLAR ON MOUNTING NUT
4
MOUNTING
SURFACE
7
5
6
4
Figure B
8
1
3
5
1