JVC GR-AXM50 manual EN Recording, Retake R/F, Feature, Purpose

18EN RECORDING

BasicFeatures

Zoom-in

Zoom-out

Zoom indicator bar

Zoom Level indicator

RETAKE (R/F)

Power zoom lever

FEATURE:	Zooming
PURPOSE:	To produce the zoom in/out effect, or
	an instantaneous change in image
	magnification.

OPERATION: 36X Hyper zoom

Digital circuitry doubles the maximum 18x magnification offered by optical zoom.

1)To zoom in, slide the Zoom Lever toward “T”.

2)To zoom out, slide toward “W”.

NOTES: ● During Hyper Zoom, the speed

	increases the further you slide the
	Zoom Lever.
	● Focusing may become unstable
	during Hyper Zoom. In this case,
	set the zoom while in Record–
	Standby, set manual focus or Focus
	Lock (☞ pg. 22, 23), then zoom in
	or out in Record mode.
	● The Zoom Level Indicator (5) only
	moves during optical zoom. Once
	the Zoom Level indicator reaches
	the top of the zoom indicator bar,
	all magnification from that point is
	through digital processing.
	● During digital image processing,
	the quality of the image may suffer.
FEATURE:	Quick Review
PURPOSE:	To check the end of the last
	recording.
OPERATION:	1) Press “ ” and release quickly
	during the Record–Standby mode.
	•Tape is rewound for about 2
	seconds and played back
	automatically, then pauses in
	Record–Standby mode for the
	next shot.
NOTE:	Distortion may occur at start of
	playback. This is normal.
FEATURE:	Retake
PURPOSE:	To re-record certain segments.
OPERATION:	1) Make sure the camcorder is in the
	Record–Standby mode.
	2) Press either RETAKE button to
	reach the start point for new
	recording. Pressing “F” forwards
	the tape and pressing “R” reverses
	it.
	3) Press Recording Start/Stop to start
	recording.
NOTE:	Noise may appear during Retake.
	This is normal.